lpc2917 NXP Semiconductors, lpc2917 Datasheet - Page 39

• Manufacturer Part Number: lpc2917
• Description: Arm9 Microcontroller With Can And Lin
• Manufacturer: NXP Semiconductors

NXP Semiconductors
LPC2917_19_1
Preliminary data sheet
8.7.6.4 Master and slave mode
8.7.6.5 PWM pin description
8.7.6.6 PWM clock description
8.7.7.1 Overview
8.7.7 Timers in the MSCSS
A PWM module can provide synchronization signals to other modules (also called Master
mode). The signal sync_out is a pulse of one clock cycle generated when the internal
PWM counter (re)starts. The signal trans_enable_out is a pulse synchronous to sync_out,
generated if a transfer from system registers to PWM shadow registers occurred when the
PWM counter restarted. A delay may be inserted between the counter start and
generation of trans_enable_out and sync_out.
A PWM module can use input signals trans_enable_in and sync_in to synchronize its
internal PWM counter and the transfer of shadow registers (Slave mode).
Each of the four PWM modules in the MSCSS has the following pins. These are combined
with other functions on the port pins of the LPC2917/19.
PWM3 pins.
Table 21.
The PWM modules are clocked by CLK_MSCSS_PWMx (x = 0-3), see
Note that each PWM has its own CLK_MSCSS_PWMx branch clock for power
management. The frequency of all these clocks is identical to CLK_MSCSS_VPB since
they are derived from the same base clock BASE_MSCSS_CLK.
Also note that unlike the timer modules in the Peripheral SubSystem, the actual timer
counter registers of the PWM modules run at the same clock as the VPB system interface
CLK_MSCSS_VPB. This clock is independent of the AHB system clock.
If a PWM module is not used its CLK_MSCSS_PWMx branch clock can be switched off.
The two timers in the MSCSS are functionally identical to the timers in the peripheral
subsystem, see
the timers in the peripheral subsystem, but the capture inputs and match outputs are not
available on the device pins. These signals are instead connected to the ADC and PWM
modules as outlined in the description of the MSCSS, see
Symbol
PWMn CAP[0]
PWMn CAP[1]
PWMn CAP[2]
PWMn MAT[0]
PWMn MAT[1]
PWMn MAT[2]
PWMn MAT[3]
PWMn MAT[4]
PWMn MAT[5]
PWMn TRAP
PWM pins
Section
Direction
in
in
in
out
out
out
out
out
out
in
Rev. 1.01 — 15 November 2007
8.4.3. The features of the timers in the MSCSS are the same as
Description
PWM n capture input 0
PWM n capture input 1
PWM n capture input 2
PWM n match output 0
PWM n match output 1
PWM n match output 2
PWM n match output 3
PWM n match output 4
PWM n match output 5
PWM n trap input
ARM9 microcontroller with CAN and LIN
Table 21
Section
LPC2917/19
shows the PWM0 to
8.7.2.
© NXP B.V. 2007. All rights reserved.
Section
7.2.2.
39 of 68