isd-t360sb ETC-unknow, isd-t360sb Datasheet - Page 77

• Manufacturer Part Number: isd-t360sb
• Manufacturer: ETC-unknow

2—SOFTWARE
MR
Erases all memory blocks and initializes the memory and message management. Bad blocks, and
blocks which are used for IVS vocabularies, are not erased. This command can be issued in either RESET
or IDLE states.
NOTE
NOTE
Example
P
Begins playback of the current message. The VoiceDSP processor state changes to PLAY. When playback
is complete, the VoiceDSP processor sets the EV_NORMAL_END bit in the status word, and activates
(clears to 0) the MWRQST signal. The state then changes to IDLE. Playback can be paused with the PA
command, and can be resumed later with the RES command. Playback can be stopped with the S
command.
If the current message is undefined, ERR_INVALID is reported.
Example
PA
Suspends the execution of the current GT, P, R, SAS, SO, SW, or SS commands. The PA command does
not change the state of the VoiceDSP processor; execution can be resumed with the RES command.
NOTE
ISD
MR
Byte sequence:
Description:
P
Byte sequence:
Description:
When Memory Reset is used in RESET state, it must be issued after the CFG command is issued,
or the memory type and number of devices are not defined. In this case the result is
unpredictable.
The command erases all messages and should be used with care.
DTMF and tone detectors remain active during Pause, Play and Record commands.
Microcontroller
VoiceDSP
Erase all memory blocks.
Microcontroller
VoiceDSP
Play the current message.
Memory Reset
Playback
Pause
ISD-T360SB
2A
2A
03
03
2-41