upd78f0114hgb-8es-a Renesas Electronics Corporation., upd78f0114hgb-8es-a Datasheet - Page 307

• Manufacturer Part Number: upd78f0114hgb-8es-a
• Description: 8-bit Single-chip Microcontrollers
• Manufacturer: Renesas Electronics Corporation.

<R>
14.4 Operation of Serial Interface CSI10
14.4.1 Operation stop mode
addition, the P10/SCK10/T
mode.
(1) Register used
Address: FF80H After reset: 00H R/W
CSIM10
Serial interface CSI10 can be used in the following two modes.
Serial communication is not executed in this mode. Therefore, the power consumption can be reduced. In
Symbol
The operation stop mode is set by serial operation mode register 10 (CSIM10).
To set the operation stop mode, clear bit 7 (CSIE10) of CSIM10 to 0.
(a) Serial operation mode register 10 (CSIM10)
Operation stop mode
3-wire serial I/O mode
CSIM10 can be set by a 1-bit or 8-bit memory manipulation instruction.
RESET input clears CSIM10 to 00H.
Notes 1.
CSIE10
CSIE10
2.
<7>
0
When using P10/SCK10/TxD0, P11/SI10/RxD0, or P12/SO10 as a general-purpose port, see
CHAPTER 4 PORT FUNCTIONS, Caution 3 of Figure 14-3, and Table 14-2.
Bit 0 (CSOT10) of CSIM10 and serial I/O shift register 10 (SIO10) are reset.
Disables operation
X
D0, P11/SI10/R
TRMD10
6
CHAPTER 14 SERIAL INTERFACE CSI10
Note 1
X
5
0
D0, and P12/SO10 pins can be used as ordinary I/O port pins in this
User’s Manual U16961EJ4V0UD
and asynchronously resets the internal circuit
Operation control in 3-wire serial I/O mode
DIR10
4
3
0
2
0
Note 2
.
1
0
CSOT10
0
307