MPC8358E Freescale Semiconductor, MPC8358E Datasheet - Page 108

• Manufacturer Part Number: MPC8358E
• Description: (MPC8358E / MPC8360E) PowerQUICC II Pro Processor Revision 2.x TBGA Silicon Hardware Specifications
• Manufacturer: Freescale Semiconductor

www.DataSheet4U.com
Document Revision History
and the I/O circuit takes on its normal function. Careful board layout with stubless connections to these
pull-up/pull-down resistors coupled with the large value of the pull-up/pull-down resistor should minimize
the disruption of signal quality or speed for output pins thus configured.
24.7
The device requires high resistance pull-up resistors (10 kΩ is recommended) on open drain type pins
including I
For more information on required pull-up resistors and the connections required for the JTAG interface,
see AN3097, MPC8360E/MPC8358E PowerQUICC™ Design Checklist, Rev. 1.
25 Document Revision History
Table 80
26 Ordering Information
Ordering information for the parts fully covered by this specification document is provided in
Section 26.1, “Part Numbers Fully Addressed by this Document.”
26.1
Table 81
individual part numbers correspond to a maximum processor core frequency. For available frequencies,
contact your local Freescale sales office. In addition to the processor frequency, the part numbering scheme
also includes an application modifier which may specify special application conditions. Each part number
also contains a revision code which refers to the die mask revision number.
108
MPC8360E/MPC8358E PowerQUICC™ II Pro Processor Revision 2.x TBGA Silicon Hardware Specifications, Rev. 2
Number
Rev.
provides a revision history for this hardware specification.
0
provides the Freescale part numbering nomenclature for the MPC8360E/58E. Note that the
Pull-Up Resistor Requirements
Part Numbers Fully Addressed by this Document
2
C pins, Ethernet Management MDIO pin, and EPIC interrupt pins.
12/07/2007 Initial release.
Date
Table 80. Document Revision History
Substantive Change(s)
Freescale Semiconductor