WM8959 Wolfson Microelectronics Ltd., WM8959 Datasheet - Page 47

• Manufacturer Part Number: WM8959
• Description: Mobile Multimedia DAC with Dual-mode Class AB/D Speaker Driver
• Manufacturer: Wolfson Microelectronics Ltd.

w
Pre-Production
In Differential Mode (AINLMODE=10, AINRMODE=10), no additional volume control is available in
the input signal path, but the Input PGA volume control can be used to adjust the signal level as with
other modes. Both PGAs on the desired channel(s) must be enabled, and the PGA volumes of each
set to the same value for true Differential input characteristics. The PGA Output (LIN12 or RIN12) to
Mixer (INMIXL or INMIXR) path must also be enabled on the desired channel(s) by use of register bit
L12MNB or R12MNB. This configuration is illustrated in Figure 26. The applicable register settings
are shown in Table 11.
Table 11 Differential Mode Register Settings
Figure 26 Differential Mode Signal Paths
Left Channel Differential
Mode
(DIFFINL to AINLMUX)
Right Channel Differential
Mode
(DIFFINR to AINRMUX)
CONFIGURATION
1. Select Differential Mode
2. Enable LIN12 input path
3. Set channel volume as required.
Important: The LIN12 and LIN34
volume and mute settings must be
set to the same value. See Table 5
for full definitions of these fields.
1. Select Differential Mode
2. Enable RIN12 input path
3. Set channel volume as required.
Important: The RIN12 and RIN34
volume and mute settings must be
set to the same value. See Table 5
for full definitions of these fields.
REGISTER SETTINGS
AINLMODE = 10
L12MNB = 1
LIN12VOL, LIN12MUTE
LIN34VOL, LIN34MUTE
AINRMODE = 10
R12MNB = 1
RIN12VOL, RIN12MUTE
RIN34VOL, RIN34MUTE
PP, May 2008, Rev 3.1
WM8959
47