P6002ZC Teccor Electronics, Inc., P6002ZC Datasheet - Page 186

• Manufacturer Part Number: P6002ZC
• Description: 275 V, four-port longitudinal two-chip protector
• Manufacturer: Teccor Electronics, Inc.

SIDACtor Soldering Recommendations
Figure 5.9 Wave Soldering Surface Mount Components Only
http://www.teccor.com
[phone]
Screen print glue
Apply glue
Wave Soldering
Another common method for soldering components to a PCB is wave soldering. After
fluxing the PCB, an adhesive is applied to the respective footprints so that components can
be glued in place. Once the adhesive has cured, the board is pre-heated and then placed in
contact with a molten wave of solder which has a temperature between 240 °C and 260 °C
and permanently affixes the component to the PCB. (Figure 5.8 and Figure 5.10)
Although a popular method of soldering, wave soldering does have drawbacks:
• A double pass is often required to remove excess solder.
• Solder bridging and shadows begin to occur as board density increases.
• Wave soldering uses the sharpest thermal gradient.
Figure 5.10 Wave Soldering Surface Mount and Leaded Components
Place component
5 - 24
Cure glue
PC board
Insert
leaded
components
Turn over the
PC board
Apply
glue
Place
SMDs
Cure
glue
Turn over the
PC board
Wave solder
SIDACtor
®
Data Book and Design Guide
Wave solder
© 2002 Teccor Electronics