P6002ZC Teccor Electronics, Inc., P6002ZC Datasheet - Page 147

• Manufacturer Part Number: P6002ZC
• Description: 275 V, four-port longitudinal two-chip protector
• Manufacturer: Teccor Electronics, Inc.

© 2002 Teccor Electronics
SIDACtor
®
Data Book and Design Guide
Note: Test conditions 2, 3, and 4 do not require the use of a wiring simulator or a secondary
Overvoltage Test Compliance
Equipment is deemed compliant if each of the following conditions are met during test:
• Absence of ignition or charring of the cheesecloth indicator
• Wiring simulator does not open during test condition 1 or 5
• For test condition 1, presented in Table 4.17, the integral I
After completion of the overvoltage tests, equipment must comply with either the Dielectric
Voltage-withstand Test requirements with all components in place or the Leakage Current
Test requirements.
Special Considerations Regarding the SIDACtor Device and UL 60950
The epoxy used for SIDACtor devices is UL recognized and the encapsulated body passes
UL 94V-0 requirements for flammability.
The only specific requirements of UL 60950 that pertain to the SIDACtor device itself are
the impulse test and the mandate that components be UL recognized. All other UL 60950
requirements pertain to the equipment being evaluated.
(Charring is deemed to have occurred when the threads are reduced to char by a
glowing or flaming condition.)
probe is less than 100 A
protector simulator. Any secondary protection simulators used in Tests 1 and 5
should be similar to the test fuse used in UL 497A, “Standard for Secondary
Protectors for Communications Circuits.”
2
s
.
4 - 23
UL 60950 3rd Edition (formerly UL 1950, 3rd edition)
2
t measured with a current
http://www.teccor.com
[phone]