M50FLW080A STMicroelectronics, M50FLW080A Datasheet - Page 50

• Manufacturer Part Number: M50FLW080A
• Description: 8 Mbit (13 x 64KByte Blocks + 3 x 16 x 4KByte Sectors) 3V Supply Firmware Hub / Low Pin Count Flash Memory
• Manufacturer: STMicroelectronics

M50FLW080A, M50FLW080B
Figure 27. Sector/Block Erase Flowchart and Pseudo Code
Note: 1. If the Block Erase command is used on a block that is split into 4KByte sectors, each of the 16 sectors of the block should be un-
50/53
2. If an error is found, the Status Register must be cleared before further Program/Erase Controller operations.
FWH/LPC
Interface
Only
locked before performing the erase operation.
Write Block/Sector
Address and D0h
Write 20h/32h
SR4, SR5 = 0
Read Status
Register
SR7 = 1
SR3 = 0
SR5 = 0
SR1 = 0
Start
End
YES
YES
YES
YES
YES
NO
NO
NO
NO
NO
Suspend
Sequence Error (1)
Block/Sector Error (1)
Erase to Protected
Erase Error (1)
V PP Invalid
Command
NO
Error (1)
YES
Suspend
Loop
Block/Sector Erase command:
– Write 20h/32h
– Write Block/Sector Address and D0h
do:
– Read Status Register
– If SR7=0 and a Program/Erase Suspend
If SR3 = 1,
– Enter the "V PP invalid" error handler
If SR4, SR5 = 1,
– Enter the "Command sequence"error handler
If SR5 = 1,
– Enter the "Erase Error" error handler
If SR1 = 1,
– Enter the "Erase to protected Block/Sector"
error handler
(memory enters read Status Register after
the Block/Sector Erase command)
– SR7 is set to 1
– Enter suspend program loop
command has been executed
AI09094