STM8L162M8 STMicroelectronics, STM8L162M8 Datasheet - Page 63

• Manufacturer Part Number: STM8L162M8
• Description: STM8L-Ultra Low Power-8 bits Microcontrollers
• Manufacturer: STMicroelectronics

Specifications of STM8L162M8

• Operating Power Supply: 1.65 to 3.6 V (without BOR), 1.8 to 3.6 V (with BOR)
• Temperature Range: − 40 to 85 or 125 °C
• 5 Low Power Modes: Wait, Low power run, Low power wait, Active-halt with RTC, Halt
• Ultralow Leakage Per I/0: 50 nA
• Fast Wakeup From Halt: 5 μs
• Max Freq: 16 MHz, 16 CISC MIPS peak
• Lcd: 8x40 or 4x44 w/ step-up converter

STM8L162R8, STM8L162M8
Table 15.
1. Positive injection is not possible on these I/Os. A negative injection is induced by V
2.
3. When several inputs are submitted to a current injection, the maximum I
Table 16.
Symbol
never be exceeded. Refer to
never be exceeded. Refer to
positive and negative injected currents (instantaneous values).
A positive injection is induced by V
T
I
Symbol
I
STG
INJ(PIN)
T
INJ(PIN)
I
I
J
VDD
VSS
I
IO
Current characteristics
Thermal characteristics
Storage temperature range
Maximum junction temperature
Total current into V
Total current out of V
Output current sunk by IR_TIM pin
(with high sink LED driver capability)
Output current sunk by any other I/O and control pin
Output current sourced by any I/Os and control pin
Injected current on true open-drain pins (PC0 and PC1)
Injected current on five-volt tolerant (FT) pins
Injected current on any other pin
Total injected current (sum of all I/O and control pins)
Table 14.
Table 14.
Doc ID 17959 Rev 2
IN
>V
Ratings
DD
for maximum allowed input voltage values.
for maximum allowed input voltage values.
DD
SS
power line (source)
while a negative injection is induced by V
ground line (sink)
Ratings
(2)
(1)
INJ(PIN)
(3)
-65 to +150
(1)
is the absolute sum of the
Electrical parameters
Value
IN
150
IN
<V
<V
SS
- 5 / +0
- 5 / +0
- 5 / +5
SS
. I
Max.
± 25
- 25
80
80
80
25
. I
INJ(PIN)
INJ(PIN)
must
must
Unit
63/121
Unit
° C
mA