STM32F417IE STMicroelectronics, STM32F417IE Datasheet - Page 157

• Manufacturer Part Number: STM32F417IE
• Description: High-performance and DSP with FPU, ARM Cortex-M4 MCU with 512 Kbytes Flash, 168 MHz CPU, Art Accelerator, Ethernet, HW crypto
• Manufacturer: STMicroelectronics

Specifications of STM32F417IE

• Core: ARM 32-bit Cortex™-M4 CPU with FPU, Adaptive real-time accelerator (ART Accelerator™) allowing 0-wait state execution from Flash memory, frequency up to 168 MHz, memory protection unit, 210 DMIPS/1.25 DMIPS/MHz (Dhrystone 2.1), and DSP instructions
• 3×12-bit, 2.4 Msps A/d Converters: up to 24 channels and 7.2 MSPS in triple interleaved mode
• General-purpose Dma: 16-stream DMA controller with FIFOs and burst support
• Up To 17 Timers: up to twelve 16-bit and two 32-bit timers up to 168 MHz, each with up to 4 IC/OC/PWM or pulse counter and quadrature (incremental) encoder input
• 10/100 Ethernet Mac With Dedicated Dma: supports IEEE 1588v2 hardware, MII/RMII
• Cryptographic Acceleration: hardware acceleration for AES 128, 192, 256, Triple DES, HASH (MD5, SHA-1), and HMAC
• Rtc: subsecond accuracy, hardware calendar

STM32F415xx, STM32F417xx
A.3
USB OTG full speed (FS) interface solutions
Figure 82. USB controller configured as peripheral-only and used
1. External voltage regulator only needed when building a V
2. The same application can be developed using the OTG HS in FS mode to achieve enhanced performance
Figure 83. USB controller configured as host-only and used in full speed mode
1. The current limiter is required only if the application has to support a V
2. The same application can be developed using the OTG HS in FS mode to achieve enhanced performance
thanks to the large Rx/Tx FIFO and to a dedicated DMA controller.
switch can be used if 5 V are available on the application board.
thanks to the large Rx/Tx FIFO and to a dedicated DMA controller.
in Full speed mode
Doc ID 022063 Rev 2
BUS
powered device.
BUS
Application block diagrams
powered device. A basic power
157/168