ATxmega64B3 Atmel Corporation, ATxmega64B3 Datasheet - Page 39

• Manufacturer Part Number: ATxmega64B3
• Manufacturer: Atmel Corporation

Specifications of ATxmega64B3

• Flash (kbytes): 64 Kbytes
• Pin Count: 64
• Max. Operating Frequency: 32 MHz
• Cpu: 8-bit AVR
• # Of Touch Channels: 16
• Hardware Qtouch Acquisition: No
• Max I/o Pins: 36
• Ext Interrupts: 36
• Usb Transceiver: 1
• Usb Speed: Full Speed
• Usb Interface: Device
• Spi: 2
• Twi (i2c): 1
• Uart: 1
• Segment Lcd: 100
• Graphic Lcd: No
• Video Decoder: No
• Camera Interface: No
• Adc Channels: 8
• Adc Resolution (bits): 12
• Adc Speed (ksps): 2000
• Analog Comparators: 2
• Resistive Touch Screen: No
• Temp. Sensor: Yes
• Crypto Engine: AES/DES
• Sram (kbytes): 4
• Eeprom (bytes): 2048
• Self Program Memory: YES
• Dram Memory: No
• Nand Interface: No
• Picopower: Yes
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 1.6 to 3.6
• Operating Voltage (vcc): 1.6 to 3.6
• Fpu: No
• Mpu / Mmu: no / no
• Timers: 2
• Output Compare Channels: 6
• Input Capture Channels: 6
• Pwm Channels: 6
• 32khz Rtc: Yes
• Calibrated Rc Oscillator: Yes

19. Hi-Res – High Resolution Extension
19.1
19.2
8074A–AVR–10/11
Features
Overview
•
•
•
The high-resolution (hi-res) extension can be used to increase the resolution of the waveform
generation output from a timer/counter by four or eight. It can be used for a timer/counter doing
frequency, single-slope PWM, or dual-slope PWM generation. It can also be used with the
AWeX if this is used for the same timer/counter.
The hi-res extension uses the peripheral 4x clock (Clk
be configured so the peripheral 4x clock frequency is four times higher than the peripheral and
CPU clock frequency when the hi-res extension is enabled.
Atmel AVR XMEGA B3 devices have one Hi-Res Extension that can be enabled for the
timer/counters pair on PORTC. The notation of this is HIRESC.
Increases waveform generator resolution up to 8x (3 bits)
Supports frequency, single-slope PWM, and dual-slope PWM generation
Supports the AWeX when this is used for the same timer/counter
PER4
). The system clock prescalers must
XMEGA B3
39