ATtiny167 Atmel Corporation, ATtiny167 Datasheet - Page 108

• Manufacturer Part Number: ATtiny167
• Manufacturer: Atmel Corporation

Specifications of ATtiny167

• Flash (kbytes): 16 Kbytes
• Pin Count: 20
• Max. Operating Frequency: 16 MHz
• Cpu: 8-bit AVR
• # Of Touch Channels: 8
• Hardware Qtouch Acquisition: No
• Max I/o Pins: 16
• Ext Interrupts: 16
• Usb Speed: No
• Usb Interface: No
• Spi: 2
• Twi (i2c): 1
• Uart: 1
• Lin: 1
• Graphic Lcd: No
• Video Decoder: No
• Camera Interface: No
• Adc Channels: 11
• Adc Resolution (bits): 10
• Adc Speed (ksps): 15
• Analog Comparators: 1
• Resistive Touch Screen: No
• Temp. Sensor: Yes
• Crypto Engine: No
• Sram (kbytes): 0.5
• Eeprom (bytes): 512
• Self Program Memory: YES
• Dram Memory: No
• Nand Interface: No
• Picopower: No
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 1.8 to 5.5
• Operating Voltage (vcc): 1.8 to 5.5
• Fpu: No
• Mpu / Mmu: no / no
• Timers: 2
• Output Compare Channels: 3
• Input Capture Channels: 1
• Pwm Channels: 9
• 32khz Rtc: Yes
• Calibrated Rc Oscillator: Yes

108
ATtiny87/ATtiny167
The synchronization and edge detector logic introduces a delay of 2.5 to 3.5 system clock
cycles from an edge has been applied to the T1 pin to the counter is updated.
Enabling and disabling of the clock input must be done when T1 has been stable for at least
one system clock cycle, otherwise it is a risk that a false Timer/Counter clock pulse is
generated.
Each half period of the external clock applied must be longer than one system clock cycle to
ensure correct sampling. The external clock must be guaranteed to have less than half the
system clock frequency (f
tor uses sampling, the maximum frequency of an external clock it can detect is half the
sampling frequency (Nyquist sampling theorem). However, due to variation of the system
clock frequency and duty cycle caused by Oscillator source (crystal, resonator, and capaci-
tors) tolerances, it is recommended that maximum frequency of an external clock source is
less than f
An external clock source can not be prescaled.
Figure 11-2. Prescaler for Timer/Counter1
Note:
1. The synchronization logic on the input pin (T1
clk_I/O
CLK
PSRn
Tn
I/O
/2.5.
Synchronization
ExtClk
< f
clk_I/O
CSn0
CSn1
CSn2
/2) given a 50/50 % duty cycle. Since the edge detec-
Clear
(1)
TIMER/COUNTERn CLOCK SOURCE
0
10-BIT T/C PRESCALER
)
is shown in
clk
Tn
Figure
11-1.
8265B–AVR–09/10