AT89C51AC3 Atmel Corporation, AT89C51AC3 Datasheet - Page 57
![no-image](/images/manufacturer_photos/0/0/79/atmel_corporation_sml.jpg)
AT89C51AC3
Manufacturer Part Number
AT89C51AC3
Description
Manufacturer
Atmel Corporation
Specifications of AT89C51AC3
Flash (kbytes)
64 Kbytes
Max. Operating Frequency
60 MHz
Cpu
8051-12C
Max I/o Pins
32
Spi
1
Uart
1
Adc Channels
8
Adc Resolution (bits)
10
Adc Speed (ksps)
62.5
Sram (kbytes)
2.25
Eeprom (bytes)
2048
Self Program Memory
API
Operating Voltage (vcc)
3.0 to 5.5
Timers
4
Isp
UART
Watchdog
Yes
Available stocks
Company
Part Number
Manufacturer
Quantity
Price
Part Number:
AT89C51AC3-RLTUM
Manufacturer:
ATMEL/爱特梅尔
Quantity:
20 000
Part Number:
AT89C51AC3-SLSIM
Manufacturer:
ATMEL/爱特梅尔
Quantity:
20 000
Hardware Boot Process
4383D–8051–02/08
Boot Loader Jump Bit (BLJB):
- This bit indicates if on RESET the user wants to jump to this application at address
@0000h on FM0 or execute the boot loader at address @F800h on FM1.
- BLJB = 0 on parts delivered with bootloader programmed.
- To read or modify this bit, the APIs are used.
Boot Vector Address (SBV):
- This byte contains the MSB of the user boot loader address in FM0.
- The default value of SBV is FFh (no user boot loader in FM0).
- To read or modify this byte, the APIs are used.
Extra Byte (EB) and Boot Status Byte (BSB):
- These Bytes are reserved for customer use.
- To read or modify these Bytes, the APIs are used.
At the falling edge of RESET, the bit ENBOOT in AUXR1 register is initialized with the
value of Boot Loader Jump Bit (BLJB).
Further at the falling edge of RESET if the following conditions (called Hardware condi-
tion) are detected:
•
•
•
The Hardware condition makes the bootloader to be executed, whatever BLJB value is.
If no hardware condition is detected, the FCON register is initialized with the value F0h.
Check of the BLJB value.
•
•
Note:
PSEN low,
EA high,
ALE high (or not connected).
–
If bit BLJB = 1:
User application in FM0 will be started at @0000h (standard reset).
If bit BLJB = 0:
Boot loader will be started at @F800h in FM1.
After Hardware Condition the FCON register is initialized with the value 00h
and the PC is initialized with F800h (FM1).
1. As PSEN is an output port in normal operating mode (running user applications or
2. To ensure correct microcontroller startup, the PSEN pin should not be tied to ground
bootloader applications) after reset it is recommended to release PSEN after the fall-
ing edge of Reset is signaled.
The hardware conditions are sampled at reset signal Falling Edge, thus they can be
released at any time when reset input is low.
during power-on.
57