AT32UC3B1128 Atmel Corporation, AT32UC3B1128 Datasheet - Page 99

• Manufacturer Part Number: AT32UC3B1128
• Manufacturer: Atmel Corporation

Specifications of AT32UC3B1128

• Flash (kbytes): 128 Kbytes
• Pin Count: 48
• Max. Operating Frequency: 60 MHz
• Cpu: 32-bit AVR
• # Of Touch Channels: 32
• Hardware Qtouch Acquisition: No
• Max I/o Pins: 28
• Ext Interrupts: 28
• Usb Transceiver: 1
• Usb Speed: Full Speed
• Usb Interface: Device
• Spi: 3
• Twi (i2c): 1
• Uart: 2
• Graphic Lcd: No
• Video Decoder: No
• Camera Interface: No
• Adc Channels: 6
• Adc Resolution (bits): 10
• Adc Speed (ksps): 384
• Resistive Touch Screen: No
• Temp. Sensor: No
• Crypto Engine: No
• Sram (kbytes): 32
• Self Program Memory: YES
• Dram Memory: No
• Nand Interface: No
• Picopower: No
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 3.0-3.6 or (1.65-1.95+3.0-3.6)
• Operating Voltage (vcc): 3.0-3.6 or (1.65-1.95+3.0-3.6)
• Fpu: No
• Mpu / Mmu: Yes / No
• Timers: 10
• Output Compare Channels: 16
• Input Capture Channels: 6
• Pwm Channels: 13
• 32khz Rtc: Yes
• Calibrated Rc Oscillator: Yes

32059L–AVR32–01/2012
- OCD
- Processor and Architecture
1. Stalled memory access instruction writeback fails if followed by a HW breakpoint
1. Local Bus to fast GPIO not available on silicon Rev B
2. Memory Protection Unit (MPU) is non functional
3. Bus error should be masked in Debug mode
4. Read Modify Write (RMW) instructions on data outside the internal RAM does not
5. Need two NOPs instruction after instructions masking interrupts
6. Clock connection table on Rev B
Consider the following assembly code sequence:
A
B
If a hardware breakpoint is placed on instruction B, and instruction A is a memory access
instruction, register file updates from instruction A can be discarded.
Fix/Workaround
Do not place hardware breakpoints, use software breakpoints instead. Alternatively, place a
hardware breakpoint on the instruction before the memory access instruction and then sin-
gle step over the memory access instruction.
Local bus is only available for silicon RevE and later.
Fix/Workaround
Memory Protection Unit (MPU) is non functional.
Fix/Workaround
Do not use the MPU.
If a bus error occurs during debug mode, the processor will not respond to debug com-
mands through the DINST register.
Fix/Workaround
A reset of the device will make the CPU respond to debug commands again.
work
Read Modify Write (RMW) instructions on data outside the internal RAM does not work.
Fix/Workaround
Do not perform RMW instructions on data outside the internal RAM.
The instructions following in the pipeline the instruction masking the interrupt through SR
may behave abnormally.
Fix/Workaround
Place two NOPs instructions after each SSRF or MTSR instruction setting IxM or GM in SR
Here is the table of Rev B
Do not use if silicon revision older than F.
99