SC16C2550BIBS,157 NXP Semiconductors, SC16C2550BIBS,157 Datasheet - Page 11

• Manufacturer Part Number: SC16C2550BIBS,157
• Description: IC DUART SOT617-1
• Manufacturer: NXP Semiconductors

Specifications of SC16C2550BIBS,157

• Features: False-start Bit Detection
• Number Of Channels: 2, DUART
• Fifo's: 16 Byte
• Voltage - Supply: 3.5 V ~ 4.5 V
• With Auto Flow Control: Yes
• With False Start Bit Detection: Yes
• With Modem Control: Yes
• With Cmos: Yes
• Mounting Type: Surface Mount
• Package / Case: 32-VFQFN Exposed Pad
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 935280309157; SC16C2550BIBS; SC16C2550BIBS

NXP Semiconductors
SC16C2550B_5
Product data sheet
6.3 FIFO operation
6.4 Hardware/software and time-out interrupts
The 16-byte transmit and receive data FIFOs are enabled by the FIFO Control Register
(FCR) bit 0. The user can set the receive trigger level via FCR bits 7:6, but not the transmit
trigger level. The receiver FIFO section includes a time-out function to ensure data is
delivered to the external CPU. An interrupt is generated whenever the Receive Holding
Register (RHR) has not been read following the loading of a character or the receive
trigger level has not been reached.
Table 6.
The interrupts are enabled by IER[3:0]. Care must be taken when handling these
interrupts. Following a reset, if Interrupt Enable Register (IER) bit 1 = 1, the SC16C2550B
will issue a Transmit Holding Register interrupt. This interrupt must be serviced prior to
continuing operations. The ISR register provides the current singular highest priority
interrupt only. A condition can exist where a higher priority interrupt may mask the lower
priority interrupt(s). Only after servicing the higher pending interrupt will the lower priority
interrupt(s) be reflected in the status register. Servicing the interrupt without investigating
further interrupt conditions can result in data errors.
When two interrupt conditions have the same priority, it is important to service these
interrupts correctly. Receive Data Ready and Receive Time Out have the same interrupt
priority (when enabled by IER[0]). The receiver issues an interrupt after the number of
characters have reached the programmed trigger level. In this case, the SC16C2550B
FIFO may hold more characters than the programmed trigger level. Following the removal
of a data byte, the user should re-check LSR[0] for additional characters. A Receive Time
Out will not occur if the receive FIFO is empty. The time-out counter is reset at the center
of each stop bit received or each time the Receive Holding Register (RHR) is read. The
actual time-out value is 4 character time, including data information length, start bit, parity
bit and the size of stop bit, that is, 1 , 1.5 or 2 bit times.
Selected trigger level (characters)
1
4
8
14
Flow control mechanism
5 V, 3.3 V and 2.5 V dual UART, 5 Mbit/s (max.), with 16-byte FIFOs
Rev. 05 — 12 January 2009
INTn pin activation
1
4
8
14
SC16C2550B
© NXP B.V. 2009. All rights reserved.
11 of 43