M29F010B70N6 Micron Technology Inc, M29F010B70N6 Datasheet - Page 12

• Manufacturer Part Number: M29F010B70N6
• Manufacturer: Micron Technology Inc

Specifications of M29F010B70N6

• Lead Free Status / Rohs Status: Not Compliant

Bus operations
3.4
3.5
3.6
3.7
3.8
12/35
Standby
When Chip Enable is High, V
impedance state and the Supply Current is reduced to the Standby level.
When Chip Enable is at V
Current I
I
Table 10: DC
During program or erase operations the memory will continue to use the Program/Erase
Supply Current, I
Automatic Standby
If CMOS levels (V
more the memory enters Automatic Standby where the internal Supply Current is reduced to
the CMOS Standby Supply Current, I
Bus Read operation is in progress.
Special bus operations
Additional bus operations can be performed to read the Electronic Signature and also to
apply and remove Block Protection. These bus operations are intended for use by
programming equipment and are not usually used in applications. They require V
applied to some pins.
Electronic Signature
The memory has two codes, the manufacturer code and the device code, that can be read
to identify the memory. These codes can be read by applying the signals listed in
Bus
Block Protection and Blocks Unprotection
Each block can be separately protected against accidental Program or Erase. Protected
blocks can be unprotected to allow data to be changed. Block Protection and Blocks
Unprotection operations must only be performed on programming equipment. For further
information refer to Application Note AN1122, Applying Protection and Unprotection to M29
Series Flash memory.
CC3
, Chip Enable should be held within V
operations.
CC2
. To further reduce the Supply Current to the CMOS Standby Supply Current,
characteristics.
CC4
CC
, for Program or Erase operations until the operation completes.
± 0.2V) are used to drive the bus and the bus is inactive for 150ns or
IH
the Supply Current is reduced to the TTL Standby Supply
IH
, the Data Inputs/Outputs pins are placed in the high-
CC3
. The Data Inputs/Outputs will still output data if a
CC
± 0.2V. For Standby current levels see
M29F010B
ID
Table 3:
to be