M29F010B70N6 Micron Technology Inc, M29F010B70N6 Datasheet - Page 10

• Manufacturer Part Number: M29F010B70N6
• Manufacturer: Micron Technology Inc

Specifications of M29F010B70N6

• Lead Free Status / Rohs Status: Not Compliant

Signal descriptions
2
2.1
2.2
2.3
2.4
2.5
2.6
10/35
Signal descriptions
See
connected to this device.
Address Inputs (A0-A16)
The Address Inputs select the cells in the memory array to access during Bus Read
operations. During Bus Write operations they control the commands sent to the Command
Interface of the internal state machine.
Data Inputs/Outputs (DQ0-DQ7)
The Data Inputs/Outputs output the data stored at the selected address during a Bus Read
operation. During Bus Write operations they represent the commands sent to the Command
Interface of the internal state machine.
Chip Enable (E)
The Chip Enable, E, activates the memory, allowing Bus Read and Bus Write operations to
be performed. When Chip Enable is High, V
Output Enable (G)
The Output Enable, G, controls the Bus Read operation of the memory.
Write Enable (W)
The Write Enable, W, controls the Bus Write operation of the memory’s Command Interface.
V
The V
The Command Interface is disabled when the V
Voltage, V
during power up, power down and power surges. If the Program/Erase Controller is
programming or erasing during this time then the operation aborts and the memory contents
being altered will be invalid.
A 0.1µF capacitor should be connected between the V
Ground pin to decouple the current surges from the power supply. The PCB track widths
must be sufficient to carry the currents required during program and erase operations, I
CC
Figure 1: Logic diagram
CC
supply voltage
Supply Voltage supplies the power for all operations (Read, Program, Erase etc.).
LKO
. This prevents Bus Write operations from accidentally damaging the data
and
Table 1: Signal
IH
, all other pins are ignored.
CC
names, for a brief overview of the signals
Supply Voltage is less than the Lockout
CC
Supply Voltage pin and the V
M29F010B
SS
CC4
.