M29W640FT70N6E Micron Technology Inc, M29W640FT70N6E Datasheet - Page 13

• Manufacturer Part Number: M29W640FT70N6E
• Manufacturer: Micron Technology Inc

Specifications of M29W640FT70N6E

• Cell Type: NOR
• Density: 64Mb
• Access Time (max): 70ns
• Interface Type: Parallel
• Boot Type: Top
• Address Bus: 23/22Bit
• Operating Supply Voltage (typ): 3/3.3V
• Operating Temp Range: -40C to 85C
• Package Type: TSOP
• Sync/async: Asynchronous
• Operating Temperature Classification: Industrial
• Operating Supply Voltage (min): 2.7V
• Operating Supply Voltage (max): 3.6V
• Word Size: 8/16Bit
• Number Of Words: 8M/4M
• Supply Current: 10mA
• Mounting: Surface Mount
• Pin Count: 48
• Lead Free Status / Rohs Status: Compliant

2.9
2.10
2.11
Reset/Block Temporary Unprotect (RP)
The Reset/Block Temporary Unprotect pin can be used to apply a Hardware Reset to the
memory or to temporarily unprotect all Blocks that have been protected.
Note that if V
if RP is at V
A Hardware Reset is achieved by holding Reset/Block Temporary Unprotect Low, V
least t
ready for Bus Read and Bus Write operations after t
See the Ready/Busy Output section,
characteristics
details.
Holding RP at V
and Erase operations on all blocks will be possible. The transition from V
slower than t
Ready/Busy Output (RB)
The Ready/Busy pin is an open-drain output that can be used to identify when the device is
performing a Program or Erase operation. During Program or Erase operations Ready/Busy
is Low, V
Erase Suspend mode.
After a Hardware Reset, Bus Read and Bus Write operations cannot begin until Ready/Busy
becomes high-impedance. See
characteristics
details.
The use of an open-drain output allows the Ready/Busy pins from several memories to be
connected to a single pull-up resistor. A Low will then indicate that one, or more, of the
memories is busy.
Byte/Word Organization Select (BYTE)
The Byte/Word Organization Select pin is used to switch between the x8 and x16 Bus
modes of the memory. When Byte/Word Organization Select is Low, V
x8 mode, when it is High, V
PLPX
OL
. After Reset/Block Temporary Unprotect goes High, V
. Ready/Busy is high-impedance during Read mode, Auto Select mode and
ID
PHPHH
PP
.
and
and
/WP is at V
ID
will temporarily unprotect the protected Blocks in the memory. Program
.
Figure 12: Reset/Block Temporary Unprotect AC
Figure 12: Reset/Block Temporary Unprotect AC
IL
IH
, then the two outermost boot blocks will remain protected even
, the memory is in x16 mode.
Table 17: Reset/Block Temporary Unprotect AC
Table 17: Reset/Block Temporary Unprotect AC
PHEL
or t
RHEL
IH
, whichever occurs last.
, the memory will be
waveforms, for more
waveforms, for more
IL
, the memory is in
IH
to V
ID
must be
IL
, for at
13/71