166981-005 FCI, 166981-005 Datasheet - Page 26

• Manufacturer Part Number: 166981-005
• Manufacturer: FCI

Specifications of 166981-005

• Lead Free Status / Rohs Status: Not Compliant

13.0 Use of Connectors with Mating Products
TITLE
Specification of Requirements for Cable Preparation, Wire Termination and
Copyright FCI
Form E-3334
Rev E
12.7
12.8
13.1
13.2
Assembly of Connectors Using 72392-type Contacts
Replacing Latches
This procedure covers both the replacement of broken or defective latch fingers as well as the wrong
latch finger having been assembled. In both cases the old latch finger is destroyed in the process and
cannot be reused. Remove the old latch finger using the latch finger removal tool, HT-0517. After the old
latch finger is removed, check the latch finger track in the latch side covers for damage to the cover and
for remaining pieces of the latch finger. Remove the remaining pieces of the old latch fingers if present.
Assemble the new latch finger per instructions in section on component assembly.
Replacing or Removing Covers
Pry the two covers apart taking care not to damage the cable or connector sub-assemblies. If
undamaged, covers may be reused up to three times. If one or more of the covers are damaged, replace
with new covers. Reassemble covers per instructions in section on component assembly. If, due to the
repair having to be made in a remote location, it is not feasible to have a cover assembly fixture (HT-
0520), the covers can be pressed together using a small vise or mallet but great care must be taken to
align the connector sub-assemblies to the covers to get a good assembly.
72476 and 72477 type Metral™ Unshielded Connectors
The cable connectors mate with all standard Metral™ 4-row headers and shrouds. Multiple cable
connectors may be plugged into one header or in the case of the 72477, the cable connector can be
plugged into two 4x6 headers. The cable connectors are end-to-end stackable and can be spaced within
16mm side-to-side. All connectors can mate with the following range of pin heights.
88940 type Metral™ Unshielded Connectors
These connectors can be used only for rear plug-up to straight Metral™ four row headers. Three varieties
of press-on retainers are available for this purpose. The retainers press onto the header pins so no extra
features are required on the board. In all cases two connectors must be placed side-to-side in the
retainers to effect latching. The retainers and thus the connectors are end-to-end stackable. All connector
can mate with the following range of pin heights.
TYPE
APPLICATION SPECIFICATION
Figure 26 Mating Headers & Shrouds
PDM: Rev:J
NUMBER
PAGE
AUTHORIZED BY
STATUS
STATUS:
J.R. Volstorf
26 of 29
UNRESTRICTED
Released
GS-20-002
REVISION
DATE
25-Apr-06
Printed: Nov 27, 2010
J
GS-01-001
.