166981-005 FCI, 166981-005 Datasheet - Page 25

• Manufacturer Part Number: 166981-005
• Manufacturer: FCI

Specifications of 166981-005

• Lead Free Status / Rohs Status: Not Compliant

TITLE
Specification of Requirements for Cable Preparation, Wire Termination and
Copyright FCI
Form E-3334
Rev E
Assembly of Connectors Using 72392-type Contacts
12.6.2.2.2 Soldering of Wire in Contact
TYPE
Figure 25 Solder Repair of Defective Insertion
APPLICATION SPECIFICATION
Remove the inserted contact with contact removal kit HT-0522. Replace the
contact with a new contact. The preferred method is to cut the wire outside the
contact but if this does not leave a long enough wire for reinsertion then the
strain relief of the contact can be opened and the wire removed. After removal of
the wire cut off the end of the wire just before were the first IDC dimple had
contacted the wire as shown in the above figure. Remove the insulation from the
wire such that after reinsertion the wire is positioned in the contact as shown in
the following figure. Reinsert the wire using the contact wire insertion repair tool
HT-0524 setting the strain relief and carefully solder the wire to the contact IDC
channel at the first set of IDC dimples or between sets of IDC dimples. The
soldering operation must be done as quickly as possible to prevent damage to
the insulator. Do not allow solder to protrude above the contact as shown in the
following figure. Only certified soldering operators should be used to make these
repairs.
•
PDM: Rev:J
NUMBER
PAGE
AUTHORIZED BY
STATUS
STATUS:
J.R. Volstorf
25 of 29
UNRESTRICTED
Released
GS-20-002
REVISION
DATE
25-Apr-06
Printed: Nov 27, 2010
J
GS-01-001
.