MT46V32M16P-5B:J Micron Technology Inc, MT46V32M16P-5B:J Datasheet - Page 41

• Manufacturer Part Number: MT46V32M16P-5B:J
• Description: IC SDRAM 512MB 200MHZ 66TSOP
• Manufacturer: Micron Technology Inc
• Series: -r

Specifications of MT46V32M16P-5B:J

• Format - Memory: RAM
• Memory Type: DDR SDRAM
• Memory Size: 512M (32Mx16)
• Speed: 5ns
• Interface: Parallel
• Voltage - Supply: 2.5 V ~ 2.7 V
• Operating Temperature: 0°C ~ 70°C
• Package / Case: 66-TSOP (0.400", 10.16mm Width)
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

Figure 16:
Figure 17:
PDF: 09005aef80a1d9d4/Source: 09005aef82a95a3a
DDR_x4x8x16_Core2.fm - 512Mb DDR: Rev. O; Core DDR Rev. D 2/11 EN
Reduced Drive Pull-Down Characteristics
Reduced Drive Pull-Up Characteristics
40. The voltage levels used are derived from a minimum V
41.
42. V
43.
44.
39e. The full ratio variation of the MAX-to-MIN pull-up and pull-down current should
39f. The full ratio variation of the nominal pull-up to pull-down current should be
80
70
60
50
40
30
20
10
0
load. In practice, the voltage levels obtained from a properly terminated bus will pro-
vide significantly different voltage values.
V
width can not be greater than 1/3 of the cycle rate. VIL undershoot: VIL (MIN) =
for a pulse width ≤ 3ns, and the pulse width can not be greater than 1/3 of the cycle
rate.
t
prevail over
t
but specify when the device output is no longer driving (
(
-10
-20
-30
-40
-50
-60
-70
-80
HZ (MAX) will prevail over
RPST end point and
0 . 0
t
0
IH
DD
RPRE).
0.0
be between 0.71 and 1.4 for device drain-to-source voltages from 0.1V to 1.0V at
the same voltage and temperature.
unity ±10%, for device drain-to-source voltages from 0.1V to 1.0V.
overshoot: V
and V
DD
0 . 5
0.5
t
DQSCK (MIN) +
Q must track each other.
IH
(MAX) = V
1 . 0
t
1.0
RPRE begin point are not referenced to a specific voltage level
V
DD
V
Q - V
OUT
41
(V)
OUT
t
DQSCK (MAX) +
t
(V)
RPRE (MAX) condition.
DD
1 . 5
1.5
Q + 1.5V for a
Micron Technology, Inc., reserves the right to change products or specifications without notice.
Electrical Specifications – DC and AC
2.0
2.0
512Mb: x4, x8, x16 DDR SDRAM
t
RPST (MAX) condition.
pulse width ≤ 3ns, and the pulse
2.5
2.5
DD
t
RPST) or begins driving
level and the referenced test
©2000 Micron Technology, Inc. All rights reserved.
t
LZ (MIN) will
–
1.5V