CC-9P-V526UJ-S Digi International, CC-9P-V526UJ-S Datasheet - Page 41

• Manufacturer Part Number: CC-9P-V526UJ-S
• Description: MOD 9P 32MB SDRAM 8MB FLASH
• Manufacturer: Digi International
• Series: -r

Specifications of CC-9P-V526UJ-S

• Module/board Type: Core Module
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• For Use With/related Products: Networking

External
Address/Data Bus
Antenna
41
ConnectCore 9P 9215, Wi-9P 9215, and 3G 9P 9215 Hardware Reference
Digi-provided application specific hardware interfaces such as UART, SD/SDIO, 1-Wire,
CAN bus, and others.
The modules provide a 17-bit address and 16-bit data bus with 2 external chip selects
for peripheral connections.
Note: When disconnecting U.FL connectors, the use of U.FL plug extraction tool
(Hirose P/N U.FL-LP-N-2 or U.FL-LP(V)-N-2) is strongly recommended to avoid
damage to the U.FL connectors on the ConnectCore Wi-9P 9215 and ConnectCore 3G
9P 9215 modules.
To mate U.FL connectors, the mating axes of both connectors must be aligned. The
"click" will confirm fully mated connection.
Do not attempt insertion at an extreme angle.
ConnectCore Wi-9P 9215 WLAN:
For the ConnectCore Wi-9P 9215, connect antennas to the primary and secondary
connectors.
The module uses the same antennas to transmit and receive the 802.11b/g RF
signal. An antenna switch is required to isolate the transmit signal from the receive
signal. The antenna switch works by alternately connecting the antennas to either
the transceiver PA transmit output or the transceiver receive input. To support this
antenna sharing scheme, the module operates in half-duplex mode; receive and
transmit operations do not occur at the same time.