XW2Z-200J-B10 Omron, XW2Z-200J-B10 Datasheet - Page 149

• Manufacturer Part Number: XW2Z-200J-B10
• Description: CONNECTOR CABLE 2M
• Manufacturer: Omron

Specifications of XW2Z-200J-B10

• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: XW2Z200JB10

Serial Communications
6-1-1
Procedure
126
Host computer
to FQM1
Command
flow
Host Link Communications
C-mode (Host Link)
commands
FINS command (with
Host Link header
and terminator)
Host Link command
Header
Command type
FINS
Terminator
The following table shows the Host Link communication functions available in
FQM1. Select the method that best suits your application.
A list of Host Link commands is provided next. Refer to the C-series Host Link
Units System Manual (W143) for details on Host Link and FINS commands.
Send host link
commands from
the host computer.
Create frame in
the host com-
puter and send
command to
the FQM1.
Receive the
response from
the FQM1.
tions method
Communica-
Set the System Setup from the
CX-Programmer. (Settings such
as the Host Link communica-
tions mode and parameters.)
Connect the Coordiator Module
to the general-purpose external
device using RS-232C.
Host computer to FQM1
Power OFF
Power ON
Directly connect the host computer in a 1:1
or 1:N system.
Directly connect the host computer in a 1:1 or
1:N system.
Send FINS com-
mands from the
host computer.
Configuration
OR
OR
Refer to CX-Programmer
Operation Manual for CX-
Programmer procedures.
Command
Command
Use this method
when communi-
cating primarily
from the host com-
puter to the FQM1.
To use FINS com-
mands, the host
computer must
send the com-
mands using a
Host Link header
and terminator.
Application and
Section 6-1
remarks