ST7538Q STMicroelectronics, ST7538Q Datasheet - Page 24

• Manufacturer Part Number: ST7538Q
• Description: IC TXRX FSK POWER LINE 44-TQFP
• Manufacturer: STMicroelectronics
• Type: Transceiverr

Specifications of ST7538Q

• Number Of Drivers/receivers: 1/1
• Voltage - Supply: 4.75 V ~ 5.25 V
• Mounting Type: Surface Mount
• Package / Case: 44-TQFP Exposed Pad, 44-eTQFP, 44-HTQFP, 44-VQFP
• For Use With: 497-5484 - BOARD EVAL ST7538 PWR LINE TXRX
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Protocol: -
• Other names: 497-5525

Functional description
5.7.3
5.7.4
24/44
Figure 10. ST7538Q PLL lock-in range
Carrier/preamble detection
The Carrier/Preamble Block is a digital Frequency detector Circuit.
It can be used to manage the MAINS access and to detect an incoming signal.
Two are the possible setting:
●
●
Header recognition
In Extended Control Register Mode (Control Register bit 21 = ”1”, see
line can be used to recognize if an header has been sent during the transmission. With
Header Recognition function enable (Control Register bit 18 = ”1”, see
line is forced low when a Frame Header is detected. If Frame Length Count function is
enabled, CD_PD is held low and a number of 16 bit word equal to the Frame Length
selected is sent to the host controller. In this case, CLR/T is forced to “0” and RxD is forced
to “0” or “1” (according the UART/SPI pin level) when Header has not been detected or after
the Frame Length has been reached.
If Frame Length Count function is disabled, an header recognition is signaled by forcing
CD_PD low for one period of CLR/T line. In this case, CLR/T and RxD signal are always
present, even if no header has been recognized.
Carrier detection: The Carrier/Preamble detection Block notifies to the host controller
the presence of a Carrier when it detects on the RAI Input a signal with an harmonic
component close to the programmed Carrier Frequency. The CD_PD signal sensitivity
is identical to the data reception sensitivity (0.5mVrms Typ. in Normal Sensitivity
Mode).
The CD_PD line is forced to a logic level low when a Carrier is detected.
Preamble detection: The Carrier/Preamble detection Block notifies to the host
controller the presence of a Carrier modulated at the Programmed Baud Rate for at
least 4 Consecutive Symbols (“1010” or “0101” are the symbols sequences detected).
CD_PD line is forced low till a Carrier signal is detected and PLL is in the lock-in range.
To reinforce the effectiveness of the information given by CD_PD Block, a digital
filtering is applied on Carrier or Preamble notification signal (See Control Register
Paragraph). The Detection Time Bits in the Control Register define the filter
performance. Increasing the Detection Time reduces the false notifications caused by
noise on main line. The Digital filter adds a delay to CD_PD notification equal to the
programmed Detection Time. When the carrier frequency disappears, CD_PD line is
held low for a period equal to the detection time and then forced high. During this time
the some spurious data caused by noise can be demodulated.
CLR/T
RxD
LOCK-IN RANGE
Table
Table
D03IN1417
11) the CD_PD
11), CD_PD
ST7538Q