ICS1893CF IDT, Integrated Device Technology Inc, ICS1893CF Datasheet - Page 89

• Manufacturer Part Number: ICS1893CF
• Description: PHYCEIVER LOW PWR 3.3V 48-SSOP
• Manufacturer: IDT, Integrated Device Technology Inc
• Series: PHYceiver™r
• Type: PHY Transceiverr

Specifications of ICS1893CF

• Protocol: MII
• Voltage - Supply: 3.14 V ~ 3.47 V
• Mounting Type: Surface Mount
• Package / Case: 48-SSOP
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Number Of Drivers/receivers: -
• Other names: 1893CF

8.2.3 Configuration Pins
ICS1893CF, Rev. K, 05/13/10
Table 8-6
Table 8-6. Configuration Pins
10/100SEL
10TCSR
100TCSR
REF_IN
REF_OUT
RESETn
Name
Pin
ICS1893CF Data Sheet Rev. J - Release
lists the configuration pins.
Number
Pin
19
20
47
46
23
9
Output
Output
Output
Output
Type
Input
Input
Pin
Copyright © 2009, Integrated Device Technology, Inc.
10Base-T / 100Base-TX Select.
10M Transmit Current Set Resistor.
100M Transmit Current Set Resistor.
(Frequency) Reference Input.
This pin is connected to a 25-MHz oscillator. For a tolerance, see
Section 9.5.1, “Timing for Clock Reference In (REF_IN)
(Frequency) Reference Output.
This pin is used with a crystal.
(System) Reset (Active Low).
•
•
•
•
•
•
•
This pin acts as an output that indicates the current status of this
pin. In this case, when the signal on this pin is logic:
– Low, this pin indicates 10Base-T operations are selected.
– High, this pin indicates 100Base-TX operations are selected.
A resistor, connected between this pin and ground, is required to
establish the value of the transmit current used in 10Base-T mode.
The value and tolerance of this resistor is specified in
“Recommended Component Values
A resistor, connected between this pin and ground, is required to
establish the value of the transmit current used in 100Base-TX
mode.
The value and tolerance of this resistor is specified in
“Recommended Component Values
When the signal on this active-low pin is logic:
– Low, the ICS1893CF is in hardware reset.
– High, the ICS1893CF is operational.
For more information on hardware resets, see the following:
–
–
Section 4.1.2.1, “Hardware Reset”
Section 9.5.16, “Reset: Hardware Reset and Power-Down”
All rights reserved.
89
Chapter 8 Pin Diagram, Listings, and Descriptions
Pin Description
*”.
*”.
Pin”.
Section 9.3,
Section 9.3,
May, 2010