HS9Z-A61 IDEC Corporation, HS9Z-A61 Datasheet - Page 13

• Manufacturer Part Number: HS9Z-A61
• Description: Straight Key for Idec HS6B Safety Switch
• Manufacturer: IDEC Corporation

Specifications of HS9Z-A61

• Lead Free Status / Rohs Status: RoHS Compliant part

398
Wire Connection
•
•
•
•
•
Manual Unlocking
•
•
•
•
•
Make an opening for wire connection by breaking one of the conduit-port
knockouts on the switch housing using a screwdriver.
Before breaking the knockout, temporarily remove the connector-fi xing lock
nut from the switch.
When breaking the knockout, take care not to damage the contact block or
other parts inside the switch.
Cracks or burrs on the conduit entry may deteriorate the housing protection.
When changing to the other conduit port, close the unused opening with an
optional plug (accessory).
Remove the screw located on the unlocking entry at the side of the switch us-
ing the key wrench included with the switch. Then insert a small screwdriver
into the switch to push the lever inside of the switch toward the indicator
until the actuator is unlocked (refer to the diagram on the right).
Insert a small screwdriver into the elliptical hole on the back of the switch,
then push the lever inside of the switch toward the indicator until the actuator
is unlocked (refer to the diagram on the right).
Regardless of door type, do not use the safety switch as a locking device.
Install a locking device independently, for example, using a metal latch (also
applicable to HS1E).
The safety switch cover can be only removed with the special key wrench
supplied with the switch or with the optional screwdriver (also applicable to
HS1B and HS1E).
Remove the screw located on the unlocking entry at the side of the switch us-
ing the key wrench included with the switch. Then insert a small screwdriver
into the switch to push the lever inside of the switch toward the indicator
until the actuator is unlocked (refer to the diagram on the right).
Caution: After the unlocking operation, put the screw back into the unlocking
entry for safety.
Precautions
Type No. HS9Z-P1
Plug
HS1C Precautions
HS1E Precautions
www.idec.com
1. This unlocking method is intended for an escape from a machine when a person is
2. Caution: After the unlocking operation, put the screw back into the unlocking entry
locked in. For access to the unlocking entry, an access hole should be opened on the
mounting panel. When opening the hole, apply proper protection against water or other
foreign objects.
for safety.
Screwdriver
Screwdriver
Door Interlock Switches
Unlock
89
Normal Position
Manual Unlocking Position
Unlock