ISP1161ABD ST-Ericsson Inc, ISP1161ABD Datasheet - Page 58

• Manufacturer Part Number: ISP1161ABD
• Description: IC USB HOST/DEVICE CTRLR 64-LQFP
• Manufacturer: ST-Ericsson Inc

Specifications of ISP1161ABD

• Controller Type: USB 2.0 Controller
• Interface: Parallel
• Voltage - Supply: 3.3V, 5V
• Current - Supply: 47mA
• Operating Temperature: -40°C ~ 85°C
• Mounting Type: Surface Mount
• Package / Case: 64-LQFP
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 568-1165; ISP1161ABD,157

Philips Semiconductors
9397 750 13962
Product data
10.3.2 HcRhDescriptorB register (R/W: 13H/93H)
Table 29:
The HcRhDescriptorB register is the second register of two describing the
characteristics of the Root Hub. These fields are written during initialization to
correspond with the system implementation. Reset values are
implementation-specific (IS).
Bit
12
11
10
9
8
7 to 2
1 to 0
HcRhDescriptorA register: bit description
Symbol
NOCP
OCPM
DT
NPS
PSM
-
NDP[1:0]
Rev. 03 — 23 December 2004
Description
NoOverCurrentProtection: This bit describes how the
overcurrent status for the Root Hub ports are reported. When this
bit is cleared, the OverCurrentProtectionMode field specifies
global or per-port reporting.
0 — overcurrent status is reported collectively for all downstream
ports
1 — no overcurrent reporting supported
OverCurrentProtectionMode: This bit describes how the
overcurrent status for the Root Hub ports is reported. At reset, this
field reflects the same mode as PowerSwitchingMode. This field is
valid only if the NoOverCurrentProtection field is cleared.
0 — overcurrent status is reported collectively for all downstream
ports.
1 — overcurrent status is reported on a per-port basis. On
power-up, clear this bit and then set it to logic 1.
DeviceType: This bit specifies that the Root Hub is not a
compound device—it is not permitted. This field will always
read/write 0.
NoPowerSwitching: These bits are used to specify whether
power switching is supported or ports are always powered. It is
implementation-specific. When this bit is cleared, the bit
PowerSwitchingMode specifies global or per-port switching.
0 — ports are power switched
1 — ports are always powered on when the HC is powered on
PowerSwitchingMode: This bit is used to specify how the power
switching of the Root Hub ports is controlled. It is
implementation-specific. This field is valid only if the
NoPowerSwitching field is cleared.
0 — all ports are powered at the same time
1 — each port is powered individually. This mode allows port
power to be controlled by either the global switch or per-port
switching. If the bit PortPowerControlMask is set, the port
responds to only port power commands (Set/ClearPortPower). If
the port mask is cleared, then the port is controlled only by the
global power switch (Set/ClearGlobalPower).
reserved
NumberDownstreamPorts: These bits specify the number of
downstream ports supported by the Root Hub. The maximum
number of ports supported by ISP1161A is 2.
Full-speed USB single-chip host and device controller
…continued
© Koninklijke Philips Electronics N.V. 2004. All rights reserved.
ISP1161A
57 of 134