DC-ME-Y402-JT Digi International, DC-ME-Y402-JT Datasheet - Page 54
![MOD ME 9210 8MB SDRAM 4MB FLASH](/photos/6/75/67531/dc-me-y402-jt_sml.jpg)
DC-ME-Y402-JT
Manufacturer Part Number
DC-ME-Y402-JT
Description
MOD ME 9210 8MB SDRAM 4MB FLASH
Manufacturer
Digi International
Type
Network Controller & Processorr
Specifications of DC-ME-Y402-JT
Module/board Type
Device Server
Data Rate
11 Mbps
Memory Type
Flash, SDRAM
Interface Type
Ethernet
Operating Voltage
3.3 V
Operating Current
250 mA
Maximum Power Dissipation
825 mW
Operating Temperature Range
- 40 C to + 85 C
Board Size
36.7 mm x 19.1 mm x 21.7 mm
Data Bus Width
32 bit
Modulation
CCK, DBPSK, DQPSK
Product
Modules
Security
64/128 bit WEP, TKIP, WPA, WPA2
For Use With/related Products
Networking
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
Other names
602-1135
RF Exposure Statement
Safety Statements
The Digi Connect Wi-ME module complies with the RF exposure limits for humans as
called out in RSS-102. It is exempt from RF evaluation based on its operating frequency of
2.4 GHz, and effective radiated power less than the 3 watt requirement for a mobile device
(>20 cm separation) operating at 2.4 GHz.
To avoid contact with electrical current:
Never install electrical wiring during an electrical storm.
Never install an ethernet connection in wet locations unless that connector is
specifically designed for wet locations.
Use caution when installing or modifying ethernet lines.
Use a screwdriver and other tools with insulated handles.
You and those around you should wear safety glasses or goggles.
Do not place ethernet wiring or connections in any conduit, outlet or junction
box containing electrical wiring.
Installation of inside wire may bring you close to electrical wire, conduit,
terminals and other electrical facilities. Extreme caution must be used to avoid
electrical shock from such facilities. You must avoid contact with all such
facilities.
Ethernet wiring must be at least 6 feet from bare power wiring or lightning rods
and associated wires, and at least 6 inches from other wire (antenna wires,
doorbell wires, wires from transformers to neon signs), steam or hot water
pipes, and heating ducts.
Do not place an ethernet connection where it would allow a person to use an
ethernet device while in a bathtub, shower, swimming pool, or similar
hazardous location.
Protectors and grounding wire placed by the service provider must not be
connected to, removed, or modified by the customer.
Do not touch un-insulated ethernet wiring if lightning is likely!
Do not touch or move the antenna(s) while the unit is transmitting or receiving.
Do not hold any component containing a radio such that the antenna is very
close to or touching any exposed parts of the body, especially the face or eyes,
while transmitting.
Do not operate a portable transmitter near unshielded blasting caps or in an
explosive environment unless it is a type especially qualified for such use
5 4