DC-ME-Y402-JT Digi International, DC-ME-Y402-JT Datasheet - Page 37
![MOD ME 9210 8MB SDRAM 4MB FLASH](/photos/6/75/67531/dc-me-y402-jt_sml.jpg)
DC-ME-Y402-JT
Manufacturer Part Number
DC-ME-Y402-JT
Description
MOD ME 9210 8MB SDRAM 4MB FLASH
Manufacturer
Digi International
Type
Network Controller & Processorr
Specifications of DC-ME-Y402-JT
Module/board Type
Device Server
Data Rate
11 Mbps
Memory Type
Flash, SDRAM
Interface Type
Ethernet
Operating Voltage
3.3 V
Operating Current
250 mA
Maximum Power Dissipation
825 mW
Operating Temperature Range
- 40 C to + 85 C
Board Size
36.7 mm x 19.1 mm x 21.7 mm
Data Bus Width
32 bit
Modulation
CCK, DBPSK, DQPSK
Product
Modules
Security
64/128 bit WEP, TKIP, WPA, WPA2
For Use With/related Products
Networking
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
Other names
602-1135
37
The following table illustrates typical power consumptions using these power management
mechanisms. These measurements were taken with all Digi NS9210 processor’s I/O clocks
disabled except UART A, UART C, Ethernet MAC, I/O Hub and Memory Clock0 with the
ethernet connected to a 100Mb network, using a standard module plugged into a Digi
JumpStart Kit development board, with nominal voltage applied:
Note 1: This measurement was taken from the R6 current sense resistor using a 0.025 ohm shunt on the
JumpStart Kit development board.
Note 2: This is the default power consumption mode when entering applicationStart(), as measured with the
napsave sample application. The value of the NS9210 Clock Configuration register (A090017C) is 0001200B
hexadecimal.
Note 3: This measurement was produced by selecting the “Clock Scale” menu option in the napsave sample
application.
Note 4: This measurement was produced by selecting the “Deep Sleep/Wakeup with an External IRA” menu
option in the napsave sample application.
Normal Operational Mode
Full Clock Scaling Mode
Sleep Mode
Mode
4
3
2
Power Consumption
1.14W (346mA)
.613W (186mA)
.113W (34mA)
1