EP4SE530H40I3 Altera, EP4SE530H40I3 Datasheet - Page 5

• Manufacturer Part Number: EP4SE530H40I3
• Description: IC STRATIX IV FPGA 530K 1517HBGA
• Manufacturer: Altera
• Series: STRATIX® IV Er

Specifications of EP4SE530H40I3

• Number Of Logic Elements/cells: 531200
• Number Of Labs/clbs: 21248
• Total Ram Bits: 27376
• Number Of I /o: 976
• Voltage - Supply: 0.87 V ~ 0.93 V
• Mounting Type: Surface Mount
• Operating Temperature: -40°C ~ 100°C
• Package / Case: 1517-HBGA
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Number Of Gates: -

Stratix IV E ES Device Issues
Table 2. Issues for Stratix IV E ES Devices (Part 2 of 2)
March 2011 Altera Corporation
I/O Jitter
Stratix IV E ES devices may exhibit higher than expected jitter on all I/O pins.
Higher Minimum f
Stratix IV E ES devices may exhibit higher than expected PLL jitter at low
f
High I/O pin leakage current
Top and bottom I/O banks show higher leakage than the published Stratix IV
Data Sheet version 2.1 specifications.
Higher standby current for V
Higher than specified standby current on the V
Reduced M9K/M144K performance
Reduced M9K/M144K performance for Stratix IV E ES devices.
DPA misalignment
Dynamic phase alignment (DPA) circuitry in Stratix IV E ES devices might get
stuck at the initial configured phase or move to the optimum phase after a
longer than expected period of time.
INPFD
settings.
Remote System Upgrade
1
INPFD
The remote system upgrade feature does not operate correctly when you initiate a
reconfiguration cycle from a factory configuration image to an invalid application
configuration image. In this scenario, Stratix IV GX and Stratix IV E devices fail to
revert to the factory configuration image after a configuration error is detected while
loading the invalid application configuration image. The failure is indicated by a
continuous toggling of the nSTATUS pin.
In correct operation, Stratix IV GX and Stratix IV E devices should revert to the factory
configuration image after a configuration error is detected with the invalid
configuration image.
An invalid application configuration image is classified as one of the following:
■
■
■
The remote system upgrade feature works correctly with all other reconfiguration
trigger conditions.
This issue is addressed by using the updated ALTREMOTE_UPDATE megafunction
and will be available in the Quartus
technical support for the software patch available with the Quartus II software
version 9.0 SP2.
Setting
A partially programmed application configuration image
A blank application configuration image
An application configuration image assigned with a wrong start address
CC
power supply
Issue
CC
supply.
®
II software version 9.1, or contact Altera
Affected Devices
EP4SE530 ES
EP4SE530 ES
EP4SE530 ES
EP4SE530 ES
EP4SE530 ES
EP4SE530 ES
devices
devices
devices
devices
devices
devices
Errata Sheet for Stratix IV E Devices
information, refer to
“DPA Misalignment”
Production devices
Production devices
production devices
production devices
production devices
Planned Fix
EP4SE530
EP4SE530
on page
EP4SE530
For more
9.
Page 5