EP1SGX25DF672I6 Altera, EP1SGX25DF672I6 Datasheet - Page 178

• Manufacturer Part Number: EP1SGX25DF672I6
• Description: IC STRATIX GX FPGA 25K 672-FBGA
• Manufacturer: Altera
• Series: Stratix® GXr

Specifications of EP1SGX25DF672I6

• Number Of Logic Elements/cells: 25660
• Number Of Labs/clbs: 2566
• Total Ram Bits: 1944576
• Number Of I /o: 455
• Voltage - Supply: 1.425 V ~ 1.575 V
• Mounting Type: Surface Mount
• Operating Temperature: -40°C ~ 100°C
• Package / Case: 672-FBGA
• Family Name: Stratix GX
• Number Of Logic Blocks/elements: 25660
• # I/os (max): 455
• Frequency (max): 5GHz
• Process Technology: SRAM
• Operating Supply Voltage (typ): 1.5V
• Logic Cells: 25660
• Ram Bits: 1944576
• Operating Supply Voltage (min): 1.425V
• Operating Supply Voltage (max): 1.575V
• Operating Temp Range: -40C to 100C
• Operating Temperature Classification: Industrial
• Mounting: Surface Mount
• Pin Count: 672
• Package Type: FC-FBGA
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Number Of Gates: -
• Lead Free Status / Rohs Status: Not Compliant

I/O Structure
4–112
Stratix GX Device Handbook, Volume 1
Slew-Rate Control
The output buffer for each Stratix GX device I/O pin has a programmable
output slew-rate control that can be configured for low-noise or high-
speed performance. A faster slew rate provides high-speed transitions for
high-performance systems. However, these fast transitions may
introduce noise transients into the system. A slow slew rate reduces
system noise, but adds a nominal delay to rising and falling edges. Each
I/O pin has an individual slew-rate control, allowing you to specify the
slew rate on a pin-by-pin basis. The slew-rate control affects both the
rising and falling edges.
Bus Hold
Each Stratix GX device I/O pin provides an optional bus-hold feature.
The bus-hold circuitry can weakly hold the signal on an I/O pin at its last-
driven state. Since the bus-hold feature holds the last-driven state of the
pin until the next input signal is present, an external pull-up or pull-down
resistor is not needed to hold a signal level when the bus is tri-stated.
Table 4–25
The bus-hold circuitry also pulls undriven pins away from the input
threshold voltage where noise can cause unintended high-frequency
switching. You can select this feature individually for each I/O pin. The
bus-hold output drives no higher than V
signals. If the bus-hold feature is enabled, the programmable pull-up
option cannot be used. Disable the bus-hold feature when using open-
drain outputs with the GTL+ I/O standard or when the I/O pin has been
configured for differential signals.
I/O pins
CLK[15..0]
CLK[0,1,2,3,8,9,10,11]
FCLK
FPLL[7..10]CLK
Table 4–25. Bus Hold Support
shows bus hold support for different pin types.
Pin Type
CCIO
to prevent overdriving
Bus Hold
v
v
Altera Corporation
February 2005