SC16C2550BIBS NXP Semiconductors, SC16C2550BIBS Datasheet - Page 39

• Manufacturer Part Number: SC16C2550BIBS
• Manufacturer: NXP Semiconductors

Specifications of SC16C2550BIBS

• Number Of Channels: 2
• Transmit Fifo: 16Byte
• Receive Fifo: 16Byte
• Transmitter And Receiver Fifo Counter: Yes
• Data Rate: 5Mbps
• Operating Supply Voltage (max): 5.5V
• Mounting: Surface Mount
• Pin Count: 32
• Operating Temperature (min): -40C
• Operating Temperature (max): 85C
• Operating Temperature Classification: Industrial
• Lead Free Status / Rohs Status: Compliant

NXP Semiconductors
13. Soldering of through-hole mount packages
SC16C2550B_5
Product data sheet
13.1 Introduction to soldering through-hole mount packages
13.2 Soldering by dipping or by solder wave
13.3 Manual soldering
For further information on temperature profiles, refer to Application Note AN10365
“Surface mount reflow soldering description” .
This text gives a very brief insight into wave, dip and manual soldering.
Wave soldering is the preferred method for mounting of through-hole mount IC packages
on a printed-circuit board.
Driven by legislation and environmental forces the worldwide use of lead-free solder
pastes is increasing. Typical dwell time of the leads in the wave ranges from
3 seconds to 4 seconds at 250 C or 265 C, depending on solder material applied, SnPb
or Pb-free respectively.
The total contact time of successive solder waves must not exceed 5 seconds.
The device may be mounted up to the seating plane, but the temperature of the plastic
body must not exceed the specified maximum storage temperature (T
printed-circuit board has been pre-heated, forced cooling may be necessary immediately
after soldering to keep the temperature within the permissible limit.
Apply the soldering iron (24 V or less) to the lead(s) of the package, either below the
seating plane or not more than 2 mm above it. If the temperature of the soldering iron bit is
less than 300 C it may remain in contact for up to 10 seconds. If the bit temperature is
between 300 C and 400 C, contact may be up to 5 seconds.
Fig 22. Temperature profiles for large and small components
temperature
MSL: Moisture Sensitivity Level
5 V, 3.3 V and 2.5 V dual UART, 5 Mbit/s (max.), with 16-byte FIFOs
Rev. 05 — 12 January 2009
= minimum soldering temperature
maximum peak temperature
minimum peak temperature
= MSL limit, damage level
SC16C2550B
temperature
peak
stg(max)
© NXP B.V. 2009. All rights reserved.
001aac844
). If the
time
39 of 43