SI5013-BM Silicon Laboratories Inc, SI5013-BM Datasheet - Page 21

• Manufacturer Part Number: SI5013-BM
• Description: IC CLOCK/DATA RECOVERY 28MLP
• Manufacturer: Silicon Laboratories Inc
• Type: Clock and Data Recovery (CDR)r

Specifications of SI5013-BM

• Input: Differential
• Output: CML
• Frequency - Max: 675MHz
• Voltage - Supply: 3.135 V ~ 3.465 V
• Operating Temperature: -40°C ~ 85°C
• Mounting Type: Surface Mount
• Package / Case: 28-VQFN Exposed Pad, 28-HVQFN, 28-SQFN, 28-DHVQFN
• Frequency-max: 675MHz
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Other names: 336-1122

GND Pad, 2
Pin #
20
22
23
24
26
27
28
CLKOUT+
BER_ALM
Pin Name
CLKOUT–
CLKDSBL
BER_LVL
REXT
GND
NC
Table 8. Si5013 Pin Descriptions (Continued)
I/O
O
O
I
I
Signal Level
LVTTL
LVTTL
GND
CML
Rev. 1.3
External Bias Resistor.
This resistor is used to establish internal bias cur-
rents within the device. This pin must be connected
to GND through a 10 kΩ (1%) resistor.
Differential Clock Output.
The output clock is recovered from the data signal
present on DIN except when LTR is asserted or the
LOL state has been entered.
Clock Disable.
When this input is high, the CLKOUT output drivers
are disabled. For normal operation, this pin should
be low.
Note: This input has a weak internal pulldown.
Bit Error Rate Level Control.
The BER threshold level is set by applying a volt-
age to this pin. When the BER exceeds the pro-
grammed threshold, BER_ALM is driven low. If this
pin is tied to GND, BER_ALM is disabled.
Bit Error Rate Alarm.
This pin will be driven low to indicate that the BER
threshold set by BER_LVL has been exceeded. The
alarm will clear after the BER rate has improved by
approximately a factor of 2.
No Connect.
Leave this pin disconnected.
Supply Ground.
Nominally 0.0 V. The GND pad found on the bottom
of the 28-lead MLP (see Figure 16 on page 23)
must be connected directly to supply ground. Min-
imize the ground path inductance for optimal perfor-
mance.
Description
Si5013
21