ISP1161A1BMGA STEricsson, ISP1161A1BMGA Datasheet - Page 21

• Manufacturer Part Number: ISP1161A1BMGA
• Manufacturer: STEricsson

Specifications of ISP1161A1BMGA

• Operating Temperature (max): 85C
• Operating Temperature (min): -40C
• Operating Temperature Classification: Industrial
• Mounting: Surface Mount
• Lead Free Status / RoHS Status: Compliant

ISP1161A1_5
Product data sheet
8.6.3 DC interrupt output pin (INT2)
To re-enable the interrupt generation:
Remark: Bit InterruptPinEnable in the HcHardwareConfiguration register latches the
interrupt output. When this bit is set to logic 0, the interrupt output will remain unchanged,
regardless of any operations on the interrupt control registers.
If INT1 is asserted, and the HCD wishes to temporarily mask off the INT signal without
clearing the HcμPInterrupt register, the following procedure should be followed:
To re-enable the interrupt generation:
The four configuration modes of DC’s interrupt output pin INT2 can also be programmed
by setting bits INTPOL and INTLVL of the DcHardwareConfiguration register (BBH to
read, BAH to write). Bit INTENA of the DcMode register (B9H to read, B8H to write) is
used to enable pin INT2.
and pin INT2.
Each of the indicated USB events is logged in a status bit of the DcInterrupt register.
Corresponding bits in the DcInterruptEnable register determine whether or not an event
will generate an interrupt.
Interrupts can be masked globally by means of bit INTENA of the DcMode register (see
Table
The active level and signalling mode of the INT output is controlled by bits INTPOL
and INTLVL of the DcHardwareConfiguration register (see
reset are active LOW and level mode. When pulse mode is selected, a pulse of 166 ns is
generated when the OR-ed combination of all interrupt bits changes from logic 0 to
logic 1.
Bits RESET, RESUME, SP_EOT, EOT and SOF are cleared upon reading the DcInterrupt
register. The endpoint bits (EP0OUT to EP14) are cleared by reading the associated
DcEndpointStatus register.
Bit BUSTATUS follows the USB bus status exactly, allowing the firmware to get the
current bus status when reading the DcInterrupt register.
SETUP and OUT token interrupts are generated after the DC has acknowledged the
associated data packet. In bulk transfer mode, the DC will issue interrupts for every ACK
received for an OUT token or transmitted for an IN token.
1. Set all bits in the HcμPInterrupt register.
2. Set bit InterruptPinEnable to logic 1.
1. Make sure that bit InterruptPinEnable is set to logic 1.
2. Clear all bits in the HcμPInterruptEnable register.
3. Set bit InterruptPinEnable to logic 0.
1. Set all bits in the HcμPInterruptEnable register according to the HCD requirements.
2. Set bit InterruptPinEnable to logic 1.
81).
Rev. 05 — 29 September 2009
Figure 21
shows the relationship between the interrupt events
USB single-chip host and device controller
Table
83). Default settings after
ISP1161A1
© ST-ERICSSON 2009. All rights reserved.
21 of 137