ISP1504A1ETTM STEricsson, ISP1504A1ETTM Datasheet - Page 44

• Manufacturer Part Number: ISP1504A1ETTM
• Manufacturer: STEricsson

Specifications of ISP1504A1ETTM

• Lead Free Status / RoHS Status: Compliant

CD00222688
Product data sheet
Fig 20. Transmitting USB packets without automatic SYNC and EOP generation
ENABLE
CLOCK
READY
STUFF
9.12 On-The-Go operations
VALID
TXBIT
DATA
[7:0]
STP
NXT
DIR
DP,
DM
TX
TX
PHY will not transmit any EOP. The ISP1504x1 will also detect if the PID byte is A5h,
indicating an SOF packet and automatically send a long EOP when STP is asserted. To
transmit chirp and resume signaling, the link must set OPMODE to 10b.
On-The-Go (OTG) is a supplement to Universal Serial Bus Specification Rev. 2.0 that
allows a portable USB device to assume the role of a limited USB host by defining
improvements, such as a small connector and low power. Non-portable devices, such as
standard hosts and embedded hosts, can also benefit from OTG features.
The ISP1504x1 OTG PHY is designed to support all the tasks specified in the OTG
supplement. The ISP1504x1 provides the front-end analog support for Host Negotiation
Protocol (HNP) and Session Request Protocol (SRP) for dual-role devices. The
supporting components include:
The following subsections describe how to use the ISP1504x1 OTG components.
•
•
•
•
TXCMD
Voltage comparators
– A_VBUS_VLD
– SESS_VLD (session valid, can be used for both A-session and B-session valid)
– SESS_END (session end)
Pull-up and pull-down resistors on DP and DM
ID detector indicates if micro-A or micro-B plug is inserted
Charge and discharge resistors on V
IDLE
00h
00h 00h 80h PID
SYNC
Rev. 04 — 20 May 2010
PID
D1
D2
ISP1504A1; ISP1504C1
BUS
D3
DATA PAYLOAD
...
...
D
N − 1
ULPI HS USB OTG transceiver
D
N
FEh
EOP
© ST-ERICSSON 2010. All rights reserved.
IDLE
004aaa719
44 of 78