IDT77V1254L25PG IDT, Integrated Device Technology Inc, IDT77V1254L25PG Datasheet - Page 27

• Manufacturer Part Number: IDT77V1254L25PG
• Manufacturer: IDT, Integrated Device Technology Inc

Specifications of IDT77V1254L25PG

• Data Rate: 25.6/51.2Mbps
• Number Of Channels: 4
• Type Of Atm Phy Interface: DPI/UTOPIA
• Operating Supply Voltage (typ): 3.3V
• Operating Supply Voltage (min): 3V
• Operating Supply Voltage (max): 3.6V
• Operating Temp Range: 0C to 70C
• Operating Temperature Classification: Commercial
• Pin Count: 144
• Mounting: Surface Mount
• Lead Free Status / RoHS Status: Not Compliant

Control and Status Interface
operating characteristics and functions, and to communicate status to external systems.
Enable (ALE) signal.
IDT77V1254L25
Utility Bus
The Utility Bus is a byte-wide interface that provides access to the registers within the IDT77V1254L25. These registers are used to select desired
The Utility Bus is implemented using a multiplexed address and data bus (AD[7:0]) where the register address is latched via the Address Latch
The Utility Bus interface is comprised of the following pins: AD[7:0], ALE, CS, RD, WR
Read Operation
Refer to the Utility Bus timing waveforms in Figures 43 and 44. A register read is performed as follows:
1. Initial condition:
2. Set up register address:
3. Read register data:
Write Operation
A register write is performed as described below:
1. Initial condition:
2. Set up register address:
3. Write data:
Interrupt Operations
P_TCLK
P_TFRM
P_TD(3:0)
– RD, WR, CS not asserted (logic 1)
– ALE not asserted (logic 0)
– place desired register address on AD[7:0]
– set ALE to logic 1;
–
– Remove register address data from AD[7:0]
– assert CS by setting to logic 0;
– assert RD by setting to logic 0
– wait minimum pulse width time (see AC specifications)
– RD, WR, CS not asserted (logic 1)
– ALE not asserted (logic 0)
– place desired register address on AD[7:0]
– set ALE to logic 1;
– latch this address by setting ALE to logic 0.
– place data on AD[7:0]
– assert CS by setting to logic 0;
– assert WR (logic 0) for minimum time (according to timing specification); reset WR to logic 1 to complete register write cycle.
latch this address by setting ALE to logic 0.
(out)
(in)
(in)
Nibble 104
Cell 1
Nibble 105
Cell 1
77V1254 Not Ready
ATM Layer Device Not Ready
Figure 30 DPI Transmit Handshake - Neither Device Ready
X
X
27 of 48
X
X
Nibble 0
Cell 2
Nibble 1
Cell 2
December 2004
Nibble 2
Cell 2
3505 drw 31
.