RAM5006E-016 Emerson Network Power, RAM5006E-016 Datasheet - Page 40

• Manufacturer Part Number: RAM5006E-016
• Manufacturer: Emerson Network Power

Specifications of RAM5006E-016

• Lead Free Status / RoHS Status: Compliant

22
3 PPCBug Firmware
MVME51005E Single Board Computer Installation and Use (6806800A38B)
If a value of zero is specified, memory will continue to be increased as needed until half of the
available memory is consumed (that is, 32MB in a 64MB system). This mode is useful for
determining the full memory required for a specific configuration. Once this is determined, a
hard value may be given to the parameter and it is guaranteed that no memory will be used over
this amount.
The default value for this parameter is one.
Note
Field Service Menu Enable [Y/N] = N?
Y
N
Remote Start Method Switch [G/M/B/N] = B?
The Remote Start Method Switch is used when the MVME5100 is cross-loaded from another
VME-based CPU in order to start execution of the cross-loaded program.
G
M
B
N
Probe System for Supported I/O Controllers [Y/N] = Y?
Y
N
Auto-Initialize of NVRAM Header Enable [Y/N] = Y?
Y
N
The bug does not automatically acquire all of the memory it is allowed. It accumulates
memory as necessary in one megabyte blocks.
Display the field service menu.
Do not display the field service menu. (Default)
Use the Global Control and Status Register to
pass and start execution of the cross-loaded
program.
Use the Multiprocessor Control Register (MPCR)
in shared RAM to pass and start execution of the
cross-loaded program.
Use both the GCSR and the MPCR methods to
pass and start execution of the cross-loaded
program. (Default)
Do not use any Remote Start Method.
Accesses will be made to the appropriate system
buses (for example, VMEbus, local MPU bus) to
determine the presence of supported controllers.
(Default)
Accesses will not be made to the VMEbus to
determine the presence of supported controllers.
NVRAM (PReP partition) header space will be
initialized automatically during board
initialization, but only if the PReP partition fails a
sanity check. (Default)
NVRAM header space will not be initialized
automatically during board initialization.