RAM5006E-016 Emerson Network Power, RAM5006E-016 Datasheet - Page 25

• Manufacturer Part Number: RAM5006E-016
• Manufacturer: Emerson Network Power

Specifications of RAM5006E-016

• Lead Free Status / RoHS Status: Compliant

PMC Modules
Figure 1-2. MVME5100 Installation and Removal From a VMEbus Chassis
PMC modules mount on top of the MVME5100. Perform the following steps to install a PMC
module on your MVME5100.
Note
Warning
Caution
2. Perform an operating system shutdown. Turn the AC or DC power off and remove the
3. If the MVME5100 has already been installed in a VMEbus card slot, carefully remove
4. Remove the filler plate(s) from the front panel of the MVME5100.
5. Align the PMC module’s mating connectors to the MVME5100’s mating connectors and
6. Insert the appropriate number of Phillips screws (typically 4) from the bottom of the
1. Attach an ESD strap to your wrist. Attach the other end of the ESD strap to an electrical
ground. Note that the system chassis may not be grounded if it is unplugged. The ESD
strap must be secured to your wrist and to ground throughout the procedure.
This procedure assumes that you have read the user’s manual that came with your
PMCs.
AC cord or DC power lines from the system. Remove chassis or system cover(s) as
necessary for access to the VME modules.
it as shown in
press firmly into place.
MVME5100 into the standoffs on the PMC module and tighten the screws (refer to
Figure
1-3).
Dangerous voltages, capable of causing death, are present in this equipment.
Use extreme caution when handling, testing and adjusting.
Inserting or removing modules with power applied may result in damage to
module components. Avoid touching areas of integrated circuitry, static
discharge can damage these circuits.
MVME51005E Single Board Computer Installation and Use (6806800A38B)
Figure 1-2
and place it with connectors P1 and P2 facing you.
1 Hardware Preparation and Installation
7