RAM5006E-016 Emerson Network Power, RAM5006E-016 Datasheet - Page 38

• Manufacturer Part Number: RAM5006E-016
• Manufacturer: Emerson Network Power

Specifications of RAM5006E-016

• Lead Free Status / RoHS Status: Compliant

Default Settings
CNFG - Configure Board Information Block
20
3 PPCBug Firmware
MVME51005E Single Board Computer Installation and Use (6806800A38B)
The following sections provide information pertaining to the firmware settings of the
MVME5100. Default (factory set) Environment (ENV) commands are provided to inform you on
how the MVME5100 was configured at the time it left the factory.
Use this command to display and configure the Board Information Block, which is resident
within the NVRAM. This data block contains various elements detailing specific operational
parameters of the MVME5100. The structure for the board is shown in the following example:
Board (PWA) Serial Number
Board Identifier
Artwork (PWA) Identifier
MPU Clock Speed
Bus Clock Speed
19. Enables the superscalar feature of the MPU (superscalar processor boards only).
20. Verifies the external bus clock speed of the MPU.
21. Determines the debugger's console/host ports and initializes the PC16550A.
22. Displays the debugger's copyright message.
23. Displays any hardware initialization errors that may have occurred.
24. Checksums the debugger object and displays a warning message if the checksum
25. Displays the amount of local read/write memory found.
26. Verifies the configuration data that is resident in NVRAM and displays a warning
27. Calculates and displays the MPU clock speed, verifies that the MPU clock speed
28. Displays the BUS clock speed, verifies that the BUS clock speed matches the
29. Probes PCI bus for supported network devices.
30. Probes PCI bus for supported mass storage devices.
31. Initializes the memory/IO addresses for the supported PCI bus devices.
32. Executes Self-Test, if so configured. (Default is no Self-Test).
33. Extinguishes the board fail LED, if Self-Test passed and outputs any warning
34. Executes boot program, if so configured. (Default is no boot.)
35. Executes the debugger monitor (that is, issues the
failed to verify.
message if the verification failed.
matches the configuration data, and displays a warning message if the verification fails.
configuration data,and displays a warning message if the verification fails.
messages.
= MOT00xxxxxxx
= MVME5100
= 01-W3518FxxB
= 450
= 100
PPC6-Bug>
prompt).