RAM5006E-016 Emerson Network Power, RAM5006E-016 Datasheet - Page 20

• Manufacturer Part Number: RAM5006E-016
• Manufacturer: Emerson Network Power

Specifications of RAM5006E-016

• Lead Free Status / RoHS Status: Compliant

Unpacking Instructions
2
1 Hardware Preparation and Installation
MVME51005E Single Board Computer Installation and Use (6806800A38B)
Note
Note
Wrist Strap
Caution
Use ESD
❏
If the shipping carton(s) is/are damaged upon receipt, request that the carrier's agent
be present during the unpacking and inspection of the equipment.
A system chassis may not be a suitable grounding source if it is unplugged.
Operating system (and/or application software)
Avoid touching areas of integrated circuitry; static discharge can damage these
circuits.
Emerson strongly recommends that you use an antistatic wrist strap and a
conductive foam pad when installing or upgrading a system.
Electronic components, such as disk drives, computer boards and memory
modules, can be extremely sensitive to electrostatic discharge (ESD). After
removing the component from its protective wrapper or from the system, place
the component on a grounded, static-free, and adequately protected working
surface. Do not slide the component over any surface. In the case of a Printed
Circuit Board (PCB), place the board with the component side facing up.
If an ESD station is not available, you can avoid damage resulting from ESD
by wearing an antistatic wrist strap (available locally) that is attached to an
active electrical ground.