9015 JEWELL / MODUTEC, 9015 Datasheet - Page 22

• Manufacturer Part Number: 9015
• Description: MULTIMETER DIGITAL HANDHELD, 3-1/2 DIGIT
• Manufacturer: JEWELL / MODUTEC

Specifications of 9015

• Dmm Type: Handheld
• Voltage Measuring Range Dc: 1000
• Voltage Measuring Range Ac: 750
• Current Measuring Range Dc: 2mA To 10A
• Current Measuring Range Ac: 20mA To 10A
• Lead Free Status / RoHS Status: na

Notes:
a) On the 2nF range, the meter will indicate residual capacitance without a
b) If the capacitor to be measured is too large to insert into the Cx socket, or
7.13.1 Connect the black test lead to the COM jack, and the red test lead to
7.13.2 Set the RANGE switch to the 20kHz position.
7.13.3 Connect the test leads to the device or circuit being measured.
7.13.4 Read frequency on the LCD display
c) The Capacitance Extension Lead may introduce error if used on the low
7.13 Measuring Frequency:
capacitor inserted into the Cx socket. This is usually less than 0.020nF.
it is installed in a piece of equipment, the provided Capacitance Extension
Lead can be used to make a measurement. Insert the Extension Lead into
the Cx socket. Use the clip leads on the other end of the Lead to make
connection to the capacitor to be tested.
capacitance ranges (like 2nF and 20nF). To minimize the error, note the
difference in reading with the lead inserted into Cx and with the lead removed
from Cx, and when using the lead, subtract the noted difference from the
displayed reading.
produce inaccurate results, and damage the meter or injure the user.
of meter to voltages exceeding 30 volts peak-to-peak. Doing so may
When in the FREQUENCY measurement mode, do not connect input
VOLT / OHM / BEEPER / DIODE / FREQ. “V
WARNING!!!
21
Ω
kHz ” jack.