9015 JEWELL / MODUTEC, 9015 Datasheet - Page 19

• Manufacturer Part Number: 9015
• Description: MULTIMETER DIGITAL HANDHELD, 3-1/2 DIGIT
• Manufacturer: JEWELL / MODUTEC

Specifications of 9015

• Dmm Type: Handheld
• Voltage Measuring Range Dc: 1000
• Voltage Measuring Range Ac: 750
• Current Measuring Range Dc: 2mA To 10A
• Current Measuring Range Ac: 20mA To 10A
• Lead Free Status / RoHS Status: na

Notes:
a) The 2M, 20M, and 200M ranges require several seconds to stabilize.
b) The 200M range reads 10 LSD high. To obtain an accurate reading, subtract
c) To obtain the most accurate reading on the 200 Ω range, short the test leads
7.8 Continuity Beeper:
7.8.1 Connect the black test lead to the COM jack and the red test lead to the
7.8.2 Set the RANGE switch to the Diode Test / Continuity Beeper
7.8.3 Connect the test probes to the device or circuit to be tested.
7.8.4 If the resistance of the device or circuit is less than 20 to 100 Ohms, the
Note: The reading displayed on the LCD is not an accurate indication of the
7.9 Diode Test:
7.9.1 Connect the black test lead to the COM jack and the red test lead to the
10 LSD from the indicated value on the LCD.
together and note the “residual resistance” reading. It is typically less than
0.5 Ω . Subtract this value from subsequent readings on the 200 Ω range.
VOLT / OHM / BEEPER / DIODE / FREQ. “V
resistance of the device or circuit being measured.
VOLT / OHM / BEEPER / DIODE / FREQ. “V
“
continuity beeper will sound.
Do not apply voltage or current to the meter when it is set
Do not apply voltage or current to the meter when it is set
to the Diode Test / Continuity Beeper “
to the Diode Test / Continuity Beeper “
” range.
WARNING!!!
WARNING!!!
18
Ω
Ω
” range.
” range.
kHz ” jack.
kHz ” jack.