9015 JEWELL / MODUTEC, 9015 Datasheet - Page 14

• Manufacturer Part Number: 9015
• Description: MULTIMETER DIGITAL HANDHELD, 3-1/2 DIGIT
• Manufacturer: JEWELL / MODUTEC

Specifications of 9015

• Dmm Type: Handheld
• Voltage Measuring Range Dc: 1000
• Voltage Measuring Range Ac: 750
• Current Measuring Range Dc: 2mA To 10A
• Current Measuring Range Ac: 20mA To 10A
• Lead Free Status / RoHS Status: na

7: MEASUREMENT PROCEDURES
7.1 Using the HOLD feature:
Note: “H” annunciator appears in the LCD when HOLD is activated.
7.2 Auto Power Off:
7.3 DC Voltage Measurement:
7.3.1 Connect the black test lead to the COM jack and the red test lead to the
The meter may not show the presence of dangerous potentials when HOLD
Do not use the meter when the low battery annunciator
If the magnitude of the voltage to be measured is unknown, always start
is activated. For example, if HOLD is applied when the meter is reading
user to believe that no hazard exists, when, in fact, dangerous voltages
This may cause the meter to produce inaccurate readings, and lead the
The 9015-A incorporates a convenient HOLD feature. This feature “freezes”
the reading in the LCD when the HOLD button is pressed. To release the
HOLD, press the HOLD button again.
The 9015-A has Auto Power Off. This power saving feature automatically
turns the meter off 15 to 20 minutes after turning it on...... thereby
extending battery life.
read zero. Failure to observe this precaution may result in damage to
If the input voltage is higher than 1000VDC (CAT I), 600V DC (CAT II),
zero, and 120VAC is subsequently applied, the meter will continue to
by setting the meter to the highest range, and then to lower ranges,
Do not rotate the RANGE switch with the input applied to the meter.
VOLT / OHM / BEEPER / DIODE / FREQ. “V
Use Caution when measuring voltages above 50V DC.
or 300V DC (CAT III), do not attempt to measure!
until a satisfactory reading is obtained.
the meter or injury to the user.
or currents are present.
WARNING!!!
WARNING!!!
WARNING!!!
13
Ω
_
+
kHz ” jack.
is displayed.