WM8350GEB/V Wolfson Microelectronics, WM8350GEB/V Datasheet - Page 137

• Manufacturer Part Number: WM8350GEB/V
• Description: Audio CODECs Audio CODEC plus pwr management
• Manufacturer: Wolfson Microelectronics

Specifications of WM8350GEB/V

• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

Production Data
14.7 CONFIGURING THE LDO REGULATORS
w
The configuration of the LDO Regulators is described in the following sections. Some of the control
fields form part of the Custom Mode configuration settings and therefore will not require to be set in
software in some applications.
14.7.1
The LDO Regulators can be enabled in software using the register fields defined in Table 81. To
reduce supply in-rush current, individual regulators should be programmed to start in different time
slots within the start-up sequence.
In the WM8350 ACTIVE state, the LDO Regulators can be enabled in software using the LDOn_ENA
bits. Setting these bits whilst in the Pre-Active state (see Figure 65) will not immediately enable the
corresponding LDO Regulators; these bits will only become effective once the WM8350 has reached
the ACTIVE state.
Each Regulator may be programmed to switch on in a selected timeslot within the start-up sequence.
The WM8350 will set the LDOn_ENA field for any LDO Regulator that is enabled during the start-up
sequence. Note that setting the LDOn_ENSLOT fields in software is only relevant to the
Development Mode, as these fields are assigned preset values in each of the Custom Modes.
Each Regulator may be programmed to switch off in a selected timeslot within the shutdown
sequence. If a Regulator is not allocated to one of the 14 shutdown timeslots, it will be disabled when
the WM8350 enters the OFF state.
R13 (0Dh) or
R176 (B0h)
DC-DC / LDO
requested
Note: These bits can be accessed through R13 or through R176. Reading from or writing to either
register location has the same effect.
ADDRESS
LDO REGULATOR ENABLE
BIT
10
11
8
9
LDO1_ENA
LDO2_ENA
LDO3_ENA
LDO4_ENA
LABEL
DEFAULT
0
0
0
0
LDO1 enable
0 = disabled
1 = enabled
Note: internal conditions may prevent the
converter from actually switching on -
see DCDC/LDO Status register for actual
converter status.
LDO2 enable
0 = disabled
1 = enabled
Note: internal conditions may prevent the
converter from actually switching on -
see DCDC/LDO Status register for actual
converter status.
LDO3 enable
0 = disabled
1 = enabled
Note: internal conditions may prevent the
converter from actually switching on -
see DCDC/LDO Status register for actual
converter status.
LDO4 enable
0 = disabled
1 = enabled
Note: internal conditions may prevent the
converter from actually switching on -
see DCDC/LDO Status register for actual
converter status.
DESCRIPTION
PD, March 2010, Rev 4.2
WM8350
137