NSH5-422UL-10M Omron, NSH5-422UL-10M Datasheet - Page 20

• Manufacturer Part Number: NSH5-422UL-10M
• Description: 10m RS422 Cable For NSH5
• Manufacturer: Omron

Specifications of NSH5-422UL-10M

• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

xx
Precautions for Safe Use
• Properly ground the PT to prevent malfunction due to noise.
• Never touch the electronic components or patterns on product boards
• When connecting the cable to the PT, make sure to secure the cable and
• Thoroughly check the wiring before supplying power.
• Turn OFF the power supply to the PT before connecting or disconnecting
• Be sure to tighten the connector screws after connecting the cable.
• The entire system may fail to operate depending on how the power supply
• Thoroughly confirm operation of screen data, macros, and host program-
• Do not perform the following operations while the Memory Card is being
• To ensure system safety, incorporate programming at the host to periodi-
• Press touch switches with a force of 30 N max.
• Confirm system safety before pressing touch switches.
• Use caution when pressing touch switches if there is no display shown or
• The inputs may not be read properly if touch switches are pressed in rapid
• Confirm that the created screen data is backed up in the CX-Designer
• When changing the password in the System Menu, do not reset the PT or
• When using the device monitor function, thoroughly confirm system safety
• Never use volatile solvents, such as paint thinner or benzene, or chemical
• Do not attempt to disassemble, repair, or modify the PT.
with your bare hands. Touch grounded metal to discharge any static elec-
tricity before handling the PT.
the PT. Do not pull on the cable with a force greater than 60 N.
the cable.
is turned ON or OFF. Follow specified procedures for turning the power
supply ON and OFF.
ming before starting actual use.
accessed.
Turning OFF the power supply to the PT
Removing the Memory Card
Always follow specified procedures for removing the Memory Card.
cally accesses a RUN signal to confirm that the PT is operating properly.
if the touch switch backlight is not lit.
succession. Confirm one input before proceeding with the next.
before initializing the screen data.
turn OFF the power supply until the write operation has been performed
(i.e., until the Write Button returns to normal). The screen may not func-
tion if the password is not properly saved.
before performing the following operations.
wipes for cleaning.
• Always use a Class 2 power supply for compliance with UL standards.
• Changing present values for monitor data, timers, or counters
• Changing the operating mode
• Force-setting/resetting bits
• Changing settings for timers or counters
A Class 2 power supply refers to one in which the current and voltage
levels of the product’s secondary output are both limited (100 VA
max.), and which has undergone and passed the necessary tests for
UL certification.
4