MTCMR-C1-GP-N3 Multi-Tech Systems, MTCMR-C1-GP-N3 Datasheet - Page 91

• Manufacturer Part Number: MTCMR-C1-GP-N3
• Description: MODEM CELLULAR DUAL CDMA
• Manufacturer: Multi-Tech Systems
• Series: MultiModem® iCellr

Specifications of MTCMR-C1-GP-N3

• Function: Transceiver, CDMA, Modem
• Modulation Or Protocol: CDMA2000
• Frequency: 800MHz, 1.9GHz, 1575.42MHz
• Applications: Verizon™ Networks (USA)
• Interface: RS-232, USB
• Sensitivity: -161dB
• Data Rate - Maximum: 153.6kbps
• Voltage - Supply: 9 V ~ 32 V, USB
• Package / Case: Module
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 881-1097

MIP Selection $QCMIPP
Description:
Syntax:
Note:
Current Active Profile $QCMIPEP
Description:
Syntax:
Values:
Return Profile Information $QCMIPGETP
Description:
Syntax:
Values:
Multi-Tech Systems, Inc. CDMA C1 AT Commands Reference Guide (PN S000478C)
This command is used to select and activate an MIP user profile.
Command syntax: AT$QCMIPP
Takes a profile number between 0 and 5. This value is stored in NV. This AT command is used to
configure Dial-Up Networking. Although 5 is the absolute maximum profile number, the actual
number may be limited by the carrier.
This command is used to enable or disable the currently active profile.
Command syntax: AT$QCMIPEP=<Val>
<Val>
This command is used to return all information corresponding to the specified profile number.
Note: The number of MIP user profiles supported is determined by the carrier.
Command syntax: AT$QCMIPGETP=<Val>
<Val>
Note: If no profile number is entered, all information corresponding to the currently active profile
is returned. If there is no profile associated with the specified number, an error is returned.
Although 5 is the absolute maximum profile number the actual number may be limited by the
carrier.
Command
AT$QCMIPP?
Note: Display the current setting
AT$QCMIPP=2
Note: Set to user profile 2
AT$QCMIPP=?
Note: Display the range of values
Command
AT$QCMIPEP?
Note: Display the current setting
AT$QCMIPEP=?
Note: Display the range of values
AT$QCMIPEP=0
Note: Set value to 0
Command
AT$QCMIPGETP?
Note: Display the current setting
AT$QCMIPGETP=?
Note: Display the range of values
AT$ CMIPGETP=0
Note: Set value to 0
0
1
(0-5)
Disable the currently active profile (profile is unavailable until it is re-enabled.
Enable the currently active profile.
Profile #
Possible Responses
$QCMIPP: 0
Note: User profile 1 is currently used
OK
Note: Command is valid
$QCMIPP: (0-5)
OK
Note: Command is valid
Possible Responses
$QCMIPEP: 1
OK
$QCMIPEP: (0-1)
OK
OK
Note: Command is valid
Possible Responses
ERROR
Note: Command is not valid
$QCMIPGETP: (0-5)
OK
Note: Command is valid
Profile:0 Enabled
…..
OK
Note: Command is valid
Note: Command is valid
Note: Command is valid
Chapter 16 – Data Commands
91