C500BC031 Omron, C500BC031 Datasheet - Page 23

• Manufacturer Part Number: C500BC031
• Description: BACKPLANE
• Manufacturer: Omron

Specifications of C500BC031

• Leaded Process Compatible: No
• Peak Reflow Compatible (260 C): No
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

Types of Interfaces
1-4
1-5
1-5-1
* When ordering, replace the “j” with the desired cable length: 1, 5, 10, 20, 30, 50, 100, 200, 400, or 500 m, e.g., Z3F2-4D30M
to order a 30 m cable.
Transmission Speed
Single-character Data
Format
Optical Interface
Optical Fiber Cable
AC Adapter
Product
Host Computer Settings
Types of Interfaces
Optical Interface
Z3RN-A-5
Z3F2-4DjM
Z3GP-01
Model Number
Note 1. The optical interface must be provided with a 5 V power supply.
To establish correct data communications with the Host Link Unit, the communi-
cations conditions listed below must match on both the host computer and the
Host Link Unit. For the actual setting of these conditions, refer to the host com-
puter manual.
The transmission speed of the Host Link Unit must match that of the host com-
puter. See Section 2 Host Link Unit Characteristics for the setting procedure.
Set the host computer to the following 11-bit data format (7-bit ASCII):
For the C200H-LK101-PV1, C200H-LK202-V1, C500-LK103(-P), and
C500-LK203 Host Link Units, the following 11-bit format can also be set (8-bit
JIS). Make sure that the host computer and Host Link Unit formats match.
The system must be properly interfaced to enable error-free communications.
Use the following information to correctly interface your system.
In an optical fiber system, the maximum transmission distance varies depending
on the type of optical fiber cable, which in turn depends on the Host Link Unit
model. Refer to the table under in Appendix C for optical fiber cable lengths. Op-
tical fiber cable connectors must be assembled by the user.
The products listed in the following table can be used to interface the
C500-LK203, 3G2A5-LK201-EV1, C200H-LK201-V1, or the 3G2A6-LK201-EV1
Host Link Unit to a host computer.
2. To supply 5 V to a Z3RN-A-5 Optical Interface connected on the host comput-
3. When using a 3G2A5-LK201-EV1 or the 3G2A6-LK201-EV1 Host Link Unit,
*
er side of a Host Link Unit (only with C500-LK203 or C200H-LK201-V1 mod-
els), set the 5 V supply switch on the back of the Host Link Unit to ON (up).
The normal setting is OFF.
use the AC adapters to supply 5 V to the Optical Interface on both the Host
Link Unit side and the host computer side.
Number of start bits:
Data Length:
Even (vertical) parity:
Number of stop bits:
Number of start bits:
Data length:
Parity (odd or even):
Number of stop bits:
2
1
1 or 2
Quantity Required
RS-232C - optical converter interface
---
For supplying power to optical interface
1
7 bits
1 bit
2
1
8 bits
1 bit
1
Miscellaneous
Section 1-5
7