LAN9215-MT SMSC, LAN9215-MT Datasheet - Page 18

• Manufacturer Part Number: LAN9215-MT
• Description: CONTROLLER, ENET, NON-PCI, 100TQFP
• Manufacturer: SMSC

Specifications of LAN9215-MT

• Data Rate: 100Mbps
• No. Of Ports: 2
• Ethernet Type: IEEE 802.3 / 802.3u
• Supply Current: 40mA
• Supply Voltage Range: 2.97V To 3.63V
• Operating Temperature Range: 0°C To +70°C
• Digital Ic Case Style: TQFP
• Interface Type: HBI
• Rohs Compliant: Yes
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

Revision 1.93 (12-12-07)
Crystal 1, Clock In
Auto-MDIX Enable
Wakeup Indicator
10/100 Selector
No Connect
Crystal 2
NAME
Reset
XTAL1/CLKIN
SPEED_SEL
AMDIX_EN
SYMBOL
nRESET
XTAL2
PME
NC
Table 2.5 System and Power Signals
Highly Efficient Single-Chip 10/100 Ethernet Controller with HP Auto-MDIX and Industrial Temperature Support
BUFFER
O8/OD8
TYPE
Oclk
(PU)
(PD)
(PU)
lclk
IS
I
I
DATASHEET
18
NUM
PINS
1
1
1
1
1
1
4
External 25MHz Crystal Input. This pin can also
be connected to single-ended TTL oscillator
(CLKIN). If this method is implemented, XTAL2
should be left unconnected.
External 25MHz Crystal output.
Active-low reset input. Resets all logic and
registers within the LAN9215i. This signal is
pulled high with a weak internal pull-up resistor.
If nRESET is left unconnected, the LAN9215i
will rely on its internal power-on reset circuitry.
Note:
When programmed to do so, is asserted when
the LAN9215i detects a wake event and is
requesting the system to wake up from the
associated sleep state. The polarity and buffer
type of this signal is programmable.
Note:
Enables Auto-MDIX. Pull high enable Auto-
MDIX, pull low or leave unconnected to disable
Auto-MDIX.
This signal functions as a configuration input on
power-up and is used to select the default
Ethernet settings. Upon deassertion of reset,
the value of the input is latched. This signal
functions as shown in
Ethernet
No Connect. These pins must be left open.
The LAN9215i must always be read at
least once after power-up, reset, or
upon return from a power-saving state
or write operations will not function.
See
Description," on page 41
information
Detection of a Power Management
Event, and assertion of the PME
signal will not wakeup the LAN9215i.
The LAN9215i will only wake up when
it detects a host write cycle (assertion
of nCS and nWR). Although any write
to the LAN9215i, regardless of the
data written, will wake-up the device
when it is in a power-saving mode, it
is required that the BYTE_TEST
register be used for this purpose.
Settings", below.
Section 3.10, "Detailed Reset
DESCRIPTION
Table 2.2, "Default
SMSC
for additional
LAN9215i
Datasheet