1323XNSK Freescale Semiconductor, 1323XNSK Datasheet - Page 13

• Manufacturer Part Number: 1323XNSK
• Description: KIT DEV FOR 1323X_NETWORK
• Manufacturer: Freescale Semiconductor
• Type: Transceiver, 802.15.4r

Specifications of 1323XNSK

• Frequency: 2.4GHz
• Interface Type: SPI
• For Use With/related Products: MC1323x
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

for rising edge / high level sensitivity, a pulldown resistor is enabled, and when enabled for falling edge /
low level sensitivity, a pull-up resistor is enabled.
The KBI features include:
8.3
The MC1323x has one serial communications interface module — sometimes called a universal
asynchronous receiver/transmitter (UART). Typically, this port is used to connect to the RS232 serial
input/output (I/O) port of a personal computer or workstation, and it can also be used to communicate with
other embedded controllers.
The SCI module has a single, flexible frac-N (13-bit modulo counter, 5-bit fractional counter) baud rate
generator used both for transmit and receive. With a maximum 16 MHz peripheral clock, baud rates as
high as 1 Mbps can be supported (standard is 921,600 baud).
This SCI system offers many advanced features not commonly found on other asynchronous serial I/O
peripherals on other embedded controllers. The receiver employs an advanced data sampling technique
that ensures reliable communication and noise detection. Hardware parity, receiver wake-up, and double
buffering on transmit and receive are also included.
Features of SCI module include:
Freescale Semiconductor
•
•
•
•
•
•
•
•
•
•
•
•
KBI1 has eight keyboard interrupt pins with individual pin enable bits.
KBI2 has four keyboard interrupt pins with individual pin enable bits.
Supports up to a 12x12 keyboard matrix. A 6x6 matrix can be supported without impacting other
I/O functions.
Each keyboard interrupt pin is programmable as falling edge (or rising edge) only, or both falling
edge and low level (or both rising edge and high level) interrupt sensitivity. Pull-ups and
pull-downs enabled by selected mode.
Individual signal software enabled interrupts for both KBI1 and KBI2.
Can be used for device wake-up
Full-duplex, standard non-return-to-zero (NRZ) format
Double-buffered transmitter and receiver with separate enables
Programmable high accuracy baud rates (frac-N generator)
Interrupt-driven or polled operation:
— Transmit data register empty and transmission complete
— Receive data register full
— Receive overrun, parity error, framing error, and noise error
— Idle receiver detect
— Active edge on receive pin
— Break detect supporting LIN
Hardware parity generation and checking
Programmable 8-bit or 9-bit character length
Serial Communications Interface (SCI) Module
MC1323x Advance Information, Rev. 1.2
13