PCA9501D,118 NXP Semiconductors, PCA9501D,118 Datasheet - Page 11

• Manufacturer Part Number: PCA9501D,118
• Description: I/O Expanders, Repeaters & Hubs 8BIT I2C FMQB GPIONT PU2K EPR
• Manufacturer: NXP Semiconductors
• Series: -r

Specifications of PCA9501D,118

• Logic Family: PCA9501
• Number Of Lines (input / Output): 8.0 / 8.0
• Operating Supply Voltage: 2.5 V to 3.6 V
• Power Dissipation: 400 mW
• Operating Temperature Range: - 40 C to + 85 C
• Input Voltage: 5 V
• Logic Type: I/O Expander
• Maximum Clock Frequency: 400 KHz
• Mounting Style: SMD/SMT
• Number Of Input Lines: 8.0
• Number Of Output Lines: 8.0
• Output Current: 25 mA
• Output Voltage: 5 V
• Package / Case: SO-20
• Mounting Type: Surface Mount
• Voltage - Supply: 2.5 V ~ 3.6 V
• Operating Temperature: -40°C ~ 85°C
• Interface: I²C, SMBus
• Number Of I /o: 8
• Frequency - Clock: 400kHz
• Interrupt Output: Yes
• Includes: EEPROM
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• For Use With: OM6285 - EVAL BOARD I2C-2002-1A568-4002 - DEMO BOARD I2C
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Lead free / RoHS Compliant
• Other names: 935272364118 PCA9501D-T

NXP Semiconductors
8. Characteristics of the I
PCA9501_4
Product data sheet
8.1.1 START and STOP conditions
8.1 Bit transfer
8.2 System configuration
The I
lines are a serial data line (SDA) and a serial clock line (SCL). Both lines must be
connected to a positive supply via a pull-up resistor when connected to the output stages
of a device. Data transfer may be initiated only when the bus is not busy.
One data bit is transferred during each clock pulse. The data on the SDA line must remain
stable during the HIGH period of the clock pulse as changes in the data line at this time
will be interpreted as control signals (see
Both data and clock lines remain HIGH when the bus is not busy. A HIGH-to-LOW
transition of the data line while the clock is HIGH is defined as the START condition (S). A
LOW-to-HIGH transition of the data line while the clock is HIGH is defined as the STOP
condition (P) (see
A device generating a message is a ‘transmitter’; a device receiving is the ‘receiver’. The
device that controls the message is the ‘master’ and the devices which are controlled by
the master are the ‘slaves’ (see
Fig 17. Bit transfer
Fig 18. Definition of START and STOP conditions
2
C-bus is for 2-way, 2-line communication between different ICs or modules. The two
SDA
SCL
START condition
2
SDA
SCL
Figure
C-bus
S
Rev. 04 — 10 February 2009
8-bit I
18).
2
C-bus and SMBus I/O port with interrupt, 2-kbit EEPROM
Figure
data valid
data line
stable;
19).
Figure
allowed
change
of data
17).
STOP condition
mba607
P
PCA9501
© NXP B.V. 2009. All rights reserved.
mba608
11 of 28